In this work a method based on self-mixing interferometry (SMI) is presented for probing the concentration of plasma plumes induced by multi-pulse laser ablation. An analytical model is developed to interpret the single-arm interferometric signal in terms of plasma electron number density. Its time dependence follows a power-law scaling which is determined by concurrent effects of plume accumulation and propagation. The model has been applied for the experimental study of plume formation at variable laser pulse frequencies on different materials. The plume expansion dynamics has been observed with high-speed imaging, and the SMI measurements allowed for a time-resolved estimation of the electron number density. The intrinsic advantages of the SMI technique in terms of robustness and low intrusiveness would allow for its usage as a fast diagnostic tool for the dynamical scaling of laser-induced plumes. Moreover it can be easily applied in laser-based manufacturing technologies where plasma concentration monitoring and control is important.
This work demonstrates the advantages of using laser powder bed fusion for producing a rudder bulb of a moth class sailing racing boat via laser powder bed fusion (LPBF). The component was designed to reduce weight using an AlSi7Mg0.6 alloy and incorporated a biomimetic surface texture for drag reduction. For the topological optimization, the component was loaded structurally due to foil wing’s lift action as well as from the environment due to hydrodynamic resistance. The aim was to minimize core mass while preserving stiffness and the second to benefit from drag reduction capability in terms of passive surface behavior. The external surface texture is inspired by scales of the European sea bass. Both these features were embedded to the component and produced by LPBF in a single run, with the required resolution. Drag reduction was estimated in the order of 1% for free stream velocity of 2.5 m s−1. The production of the final part resulted in limited geometrical error with respect to scales 3D model, with the desired mechanical properties. A reduction in weight of approximately 58% with respect to original full solid model from 452 to 190 g was achieved thanks to core topology optimization. Sandblasting was adopted as finishing technique since it was able to improve surface quality while preserving fish scale geometries. The feasibility of producing the biomimetic surfaces and the weight reduction were validated with the produced full-sized component.