All-digital radio-over-fiber (RoF) transmission has attracted a significant amount of interest in digital-centric systems or centralized networks because it greatly simplifies the front-end hardware by using digital processing. The sigma-delta modulator (SDM)-based all-digital RoF approach pushes the digital signal processing as far as possible into the transmit chain. We present a real-time 100-GS/s fourth-order single-bit SDM for all-digital RoF transmission in the high-frequency band without the aid of analog/optical up-conversion. This is the fastest sigma-delta modulator reported and this is also the first real-time demonstration of sigma-delta modulated RoF in the frequency band above 24 GHz. 4.68 Gb/s (2.34 Gb/s) 64-QAM is transported over 10-km standard single-mode fiber in the C-band with 6.46% (4.73%) error vector magnitude and 3.13 Gb/s 256-QAM can be even received in an optical back-to-back configuration. The carrier frequency can be digitally tuned at run-time, covering a wide frequency range from 22.75 GHz to 27.5 GHz. Besides, this high-speed sigma-delta modulator introduces less than 1 μs latency in the transmit chain. Its all-digital nature enables network virtualization, making the transmitter compatible with different existing standards. The prominent performance corroborates the strong competitiveness of this SDM-based RoF approach in high-frequency radio-over-fiber 5G communication.
2 August 2018 in IEEE Transactions on Wireless Communications
In-band full-duplex (FD) wireless communication allows the simultaneous transmission and reception of data at the same frequency band, effectively doubling the spectral efficiency and data rate while reducing the latency. Previously published designs mostly target the self-interference (SI) cancellation in conventional wireless systems. In this paper, we focus on real-time SI cancellation for short-reach wireless FD systems. The superior signal quality of a point-to-point short-reach wireless system, allows the utilization of wideband communications to achieve a high throughput. Besides, in such wireless systems, the impacts of phase noise and nonlinear distortions are largely reduced, easing the SI cancellation. Moreover, the degradation of signal reception quality due to FD operation is experimentally evaluated in different environments. Experimental results of a prototype implementation show that a combination of antenna isolation and digital cancellation can already achieve an overall SI cancellation performance of 72.5 dB over a bandwidth of 123 MHz. This prototype can support a high-data-rate FD communication link of close to 1 Gbps up to 300 cm with an error vector magnitude lower than -26 dB in a typical indoor environment.
26 July 2018 in IEEE Transactions on Circuits and Systems II: Express Briefs
A new high-speed delta-sigma modulator (DSM) topology is proposed by cascading a bit reduction process with a multi-stage noise shaping MASH-1-1 DSM. This process converts the two-bit output sequence of the MASH-1-1 DSM to a single-bit sequence, merely compromising the DSM noise-shaping performance. Furthermore, the high clock frequency requirements are significantly relaxed by using parallel processing. This DSM topology facilitates the design of e.g. wideband software defined radio (SDR) transmitters and delta-sigma radio-over-fiber transmitters. Experimental results of the FPGA implementation show that the proposed low-pass DSM can operate at 21 GS/s, providing 520 MHz baseband bandwidth with 42.76 dB signal-to-noise-and-distortion ratio (SNDR) or 1.1 GHz bandwidth with 32.04 dB SNDR (based on continuous wave measurements). An all-digital transmitter based on this topology can generate 218.75 MBd 256-QAM over 200 m OM4 multimode fiber in real-time, with 7-GS/s sampling rate and an error vector magnitude below 1.89%.
16 October 2019 in Journal of Lightwave Technology
To achieve the massive device connectivity and high data rate demanded by 5G, wireless transmission with wider signal bandwidths and higher-order multiple-input multiple-output (MIMO) is inevitable. This work demonstrates a possible function split option for the next generation fronthaul interface (NGFI). The proof-of-concept downlink architecture consists of real-time sigma-delta modulated signal over fiber (SDoF) links in combination with distributed multi-user (MU) MIMO transmission. The setup is fully implemented using off-the-shelf and in-house developed components. A single SDoF link achieves an error vector magnitude (EVM) of 3.14% for a 163.84 MHz-bandwidth 256-QAM OFDM signal (958.64 Mbps) with a carrier frequency around 3.5 GHz transmitted over 100-m OM4 multi-mode fiber at 850 nm using a commercial QSFP module. The centralized architecture of the proposed setup introduces no frequency asynchronism among remote radio units. For most cases, the 2×2 MU-MIMO transmission has little performance degradation compared to SISO, 0.8 dB EVM degradation for 40.96 MHz-bandwidth signals and 1.4 dB for 163.84 MHz-bandwidth on average, implying that the wireless spectral efficiency almost doubles by exploiting spatial multiplexing. A 1.4 Gbps data rate (720 Mbps per user, 163.84 MHz-bandwidth, 64-QAM) is reached with an average EVM of 6.66%. The performance shows that this approach is feasible for the high-capacity hot-spot scenario.
27 February 2020 in Journal of Lightwave Technology
The fifth generation (5G) cellular network is expected to include the millimeter wave spectrum, to increase base station density, and to employ higher-order multiple-antenna technologies. The centralized radio access network architectures combined with radio-over-fiber (RoF) links can be the key enabler to improve fronthaul networks. The sigma-delta modulated signal over fiber (SDoF) architecture has been proposed as a solution leveraging the benefits of both digitized and analog RoF. This work proposes a novel distributed antenna system using sigma-delta modulated intermediate-frequency signal over fiber (SDIFoF) links. The system has an adequately good optical bit-rate efficiency and high flexibility to switch between different carrier frequencies. The SDIFoF link transmits a signal centered at a 2.5 GHz intermediate frequency over a 100 m multi-mode fiber and the signal is up-converted to the radio frequency (24-29 GHz) at the remote radio unit. An average error vector magnitude (EVM) of 6.40% (-23.88 dB) is achieved over different carrier frequencies when transmitting a 300 MHz-bandwidth 64-QAM OFDM signal. The system performance is demonstrated by a 2×1 multiple-input single-output system transmitting 160 MHz-bandwidth 64-QAM OFDM signals centered at 25 GHz. Owing to transmit diversity, an average gain of 1.12 dB in EVM is observed. This work also evaluates the performance degradation caused by asynchronous phase noise between remote radio units. The performance shows that the proposed approach is a competitive solution for the 5G downlink fronthaul network for frequency bands above 24 GHz.
24 December 2018 in IEEE Photonics Technology Letters
In this work we present a silicon photonics Radioover- Fiber transmitter with microwave photonic up-conversion capability. The circuit consists of a pair of parallel GeSi EAMs in a MZI structure. We show that the up-converter/transmitter can up-convert 64-QAM data on a 1.5 GHz IF to any output carrier frequency in the 7-26 GHz range. This interval is only limited by measurement equipment, as we demonstrate that the EAM has a 3 dB bandwidth exceeding 65 GHz. Furthermore, the linearity of the up-converter/transmitter is characterized and a SFDR larger than 82 dB·Hz2/3 is demonstrated. Using this system we transmit up to 1.3 Gb/s 64-QAM data over 2 km of SMF with a received 5.4 % rms EVM.