All-digital radio-over-fiber (RoF) transmission has attracted a significant amount of interest in digital-centric systems or centralized networks because it greatly simplifies the front-end hardware by using digital processing. The sigma-delta modulator (SDM)-based all-digital RoF approach pushes the digital signal processing as far as possible into the transmit chain. We present a real-time 100-GS/s fourth-order single-bit SDM for all-digital RoF transmission in the high-frequency band without the aid of analog/optical up-conversion. This is the fastest sigma-delta modulator reported and this is also the first real-time demonstration of sigma-delta modulated RoF in the frequency band above 24 GHz. 4.68 Gb/s (2.34 Gb/s) 64-QAM is transported over 10-km standard single-mode fiber in the C-band with 6.46% (4.73%) error vector magnitude and 3.13 Gb/s 256-QAM can be even received in an optical back-to-back configuration. The carrier frequency can be digitally tuned at run-time, covering a wide frequency range from 22.75 GHz to 27.5 GHz. Besides, this high-speed sigma-delta modulator introduces less than 1 μs latency in the transmit chain. Its all-digital nature enables network virtualization, making the transmitter compatible with different existing standards. The prominent performance corroborates the strong competitiveness of this SDM-based RoF approach in high-frequency radio-over-fiber 5G communication.

A new high-speed delta-sigma modulator (DSM) topology is proposed by cascading a bit reduction process with a multi-stage noise shaping MASH-1-1 DSM. This process converts the two-bit output sequence of the MASH-1-1 DSM to a single-bit sequence, merely compromising the DSM noise-shaping performance. Furthermore, the high clock frequency requirements are significantly relaxed by using parallel processing. This DSM topology facilitates the design of e.g. wideband software defined radio (SDR) transmitters and delta-sigma radio-over-fiber transmitters. Experimental results of the FPGA implementation show that the proposed low-pass DSM can operate at 21 GS/s, providing 520 MHz baseband bandwidth with 42.76 dB signal-to-noise-and-distortion ratio (SNDR) or 1.1 GHz bandwidth with 32.04 dB SNDR (based on continuous wave measurements). An all-digital transmitter based on this topology can generate 218.75 MBd 256-QAM over 200 m OM4 multimode fiber in real-time, with 7-GS/s sampling rate and an error vector magnitude below 1.89%.

To achieve the massive device connectivity and high data rate demanded by 5G, wireless transmission with wider signal bandwidths and higher-order multiple-input multiple-output (MIMO) is inevitable. This work demonstrates a possible function split option for the next generation fronthaul interface (NGFI). The proof-of-concept downlink architecture consists of real-time sigma-delta modulated signal over fiber (SDoF) links in combination with distributed multi-user (MU) MIMO transmission. The setup is fully implemented using off-the-shelf and in-house developed components. A single SDoF link achieves an error vector magnitude (EVM) of 3.14% for a 163.84 MHz-bandwidth 256-QAM OFDM signal (958.64 Mbps) with a carrier frequency around 3.5 GHz transmitted over 100-m OM4 multi-mode fiber at 850 nm using a commercial QSFP module. The centralized architecture of the proposed setup introduces no frequency asynchronism among remote radio units. For most cases, the 2×2 MU-MIMO transmission has little performance degradation compared to SISO, 0.8 dB EVM degradation for 40.96 MHz-bandwidth signals and 1.4 dB for 163.84 MHz-bandwidth on average, implying that the wireless spectral efficiency almost doubles by exploiting spatial multiplexing. A 1.4 Gbps data rate (720 Mbps per user, 163.84 MHz-bandwidth, 64-QAM) is reached with an average EVM of 6.66%. The performance shows that this approach is feasible for the high-capacity hot-spot scenario.

The fifth generation (5G) cellular network is expected to include the millimeter wave spectrum, to increase base station density, and to employ higher-order multiple-antenna technologies. The centralized radio access network architectures combined with radio-over-fiber (RoF) links can be the key enabler to improve fronthaul networks. The sigma-delta modulated signal over fiber (SDoF) architecture has been proposed as a solution leveraging the benefits of both digitized and analog RoF. This work proposes a novel distributed antenna system using sigma-delta modulated intermediate-frequency signal over fiber (SDIFoF) links. The system has an adequately good optical bit-rate efficiency and high flexibility to switch between different carrier frequencies. The SDIFoF link transmits a signal centered at a 2.5 GHz intermediate frequency over a 100 m multi-mode fiber and the signal is up-converted to the radio frequency (24-29 GHz) at the remote radio unit. An average error vector magnitude (EVM) of 6.40% (-23.88 dB) is achieved over different carrier frequencies when transmitting a 300 MHz-bandwidth 64-QAM OFDM signal. The system performance is demonstrated by a 2×1 multiple-input single-output system transmitting 160 MHz-bandwidth 64-QAM OFDM signals centered at 25 GHz. Owing to transmit diversity, an average gain of 1.12 dB in EVM is observed. This work also evaluates the performance degradation caused by asynchronous phase noise between remote radio units. The performance shows that the proposed approach is a competitive solution for the 5G downlink fronthaul network for frequency bands above 24 GHz.

Exploring mmWave frequencies and adopting small-cell architectures are two key enablers for increased wireless data rates. To make these evolutions economically viable, centralized architectures based on radio-over-fiber (RoF) are devised. To reduce the complexity of the cellular network even further, RF-over-Fiber transmission schemes are adopted in combination with reflective uplink operation. This paper relies on a very low complexity narrowband GaAs electronics / Si photonics transceiver for scalable RFoF architectures with which we demonstrate a fiber-wireless link capable of transmitting over 7 Gb/s in down- and uplink for a 2km fiber and 5m wireless link in the 28 GHz band. Furthermore, it is shown that Rayleigh degradation caused by reflective uplink operation can be avoided by using a coherent detection scheme.

Analog radio-over-fiber transceivers allow a substantial reduction in the complexity of the remote radio heads in the wireless network of the future. In this paper we discuss the building blocks for such a transceiver implemented on a silicon photonics platform, with the heterogeneous integration of III-V devices and the co-integration with electronics. Transmission experiments that demonstrate the viability of such integrated analog transceivers are described.