Tailoring the partitioning behavior of solid solution strengtheners is a crucial design strategy for advanced Ni-based superalloys. The goal of this study was to maximize the enrichment of Mo, Re, Ru and W in the γ-matrix phase. To determine the composition dependency of the partitioning behavior, a set of polycrystalline superalloys with varying contents of these solid solution-strengthening elements and a W-containing single-crystalline alloy series with varying concentrations of the γ′-forming elements Ta and Ti was produced. Assessed properties include phase compositions by electron-probe micro-analysis, phase transformation temperatures by differential scanning calorimetry and creep behavior. Re exhibits the most pronounced enrichment in the γ-matrix, followed by Mo, Ru and W. Due to the preference of the Al-sites in the γ′-phase in the order Ta > Ti > W > Mo > Re, the solid solution strengthening elements Mo, Re and W are displaced from the γ′-phase by increasing Ti and Ta contents. The investigated solutes do not directly influence the partitioning behavior of Ru as it prefers Ni-sites in the γ′-phase. Compressive creep experiments reveal a correlation between the content of solid solution strengtheners in the γ-phase and creep performance.
Computational superalloy development is a powerful alternative to the conventional experimental approach. Based on thermodynamic databases and the CALPHAD method, it is possible to estimate the properties of a large number of potential alloys and select the most promising ones. However, the accuracy of the databases and complementary property models can be unsatisfying. The accuracy of two mass density and lattice parameter models and the TTNI8 and TCNI10 databases is analyzed in detail on the experimental basis of computationally optimized single‐crystalline superalloys. Various properties are measured and compared to the results of the property models and databases. Neither of the databases is superior to the other and especially the solvus temperature is not accurately described in both. The new mass density model, a linear regression based on the molar mass, is more reliable for low‐density alloys. Both lattice parameter model versions slightly overestimate the room‐temperature lattice parameter. The lattice parameter, however, is more accurately calculated using the new model version. The results of this study can be readily used to improve a multicriteria alloy optimization tool for computational superalloy design.
29 December 2023 in Advanced Engineering Materials
Cost‐ and time‐demanding trial‐and‐error methods have been the historical route for alloy development. A combinatorial approach can significantly simplify and accelerate the development process by characterization of composition dependent properties on material libraries, which are specimens or sets of specimens that map out a certain composition space, often employing composition profiles. Herein, a promising production method for such a material library is proposed: laser‐remelting of stacked blocks of different compositions is evaluated for its suitability to produce material libraries, using the ternary CrCoNi system for a proof‐of‐concept. The composition profiles of the successfully created CrCoNi material library were measured by electron probe micro analysis. The intermixing has a length of about 2.5 mm. An analytical model describing the intermixing process is proposed and shows value in the estimation of the intermixing length after the first melting step. The comparison of the experimental microstructure observations from this work and from literature shows mostly good agreement with some deviations related to microsegregation and finite quenching cooling rates, which is supported by thermodynamic calculations regarding phase stability. In the single‐phase region, the mechanical properties as measured via microhardness indentation are discussed as potential candidates for model validation.