Isolation rooms are crucial in healthcare facilities to prevent the spread of infectious diseases. Infectious diseases can be transmitted to humans from humans or through animals known as zoonoses. With the increase in the number of COVID-19 cases, isolation rooms have become one of the most critical facilities in hospitals. Maintaining the correct temperature and humidity in these isolation rooms is a challenge, considering the heating, ventilation, and air conditioning (HVAC) systems that continuously consume large amounts of energy. With the application of energy conservation methods, the total energy consumption of HVAC systems can be reduced. Many studies have shown that the heat pipe heat exchanger (HPHE) technology can contribute significantly to energy savings using HVAC systems. In this study, the effectiveness of an HPHE on an HVAC system in an isolation room was examined, and the total energy reduction was quantified. The HPHE consisted of two rows with ten heat pipes in each row, arranged in a staggered configuration with fresh air temperature and mass flow variations. The inlet fresh air temperatures varied at 32, 35, 37, and 40 °C and fresh air velocities at 1.2, 1.6, 2.2, and 2.6 m/s. Using a chiller, the inlet fresh air was cooled to a comfortable temperature zone, approximately 24.4–25.2 °C, in the isolation room. Notably, higher velocities decreased the effectiveness of the HPHE. An increase in the flow rate enhanced the system, thereby improving the heat recovery value. The increase in the inlet fresh air temperature from 32 °C, that yielded an energy saving of 1.23 W, to 40 °C, resulted in a further energy saving of 1.85 W. The application of the HPHE in the HVAC system in isolation rooms represents a significant innovation that contributes to a reduction in total energy consumption.

Despite the rapid development of electric vehicles, the shrinking number of fossil fuels that are the source of electricity remains conventional. The availability of energy sources and technology is sometimes naturally limited, high-priced, and might be politically circumscribed. This leads to an increased desirability of biodiesel due to its modest and economically higher energy density in comparison to batteries. The palm oil industry accounts for 23% of total deforestation in Indonesia. Contrary to palm oil, pangium edule (PE) is considered more sustainable and it intercrops with most of the forest’s vegetation while supplying biodiesel feedstock. A relatively higher pangium edule methyl ester (PEME) was delivered through PE feedstock, provided that it was processed with a heterogeneous catalyst, K2O/PKS-AC. This feedstock consumed a lower alcohol ratio and had a reasonably swift production process without sacrificing biodiesel quality. Therefore, this study aims to assess the performance of the PE biodiesel blend in a power generator. Furthermore, PEME was blended with diesel fuel in the variation of B0, B20, B30, B40, and B100. It was also tested with four-stroke single-cylinder diesel power generators to produce electricity. The B30 blend stands out in this experiment, achieving the highest engine power of 0.845 kW at a low load and dominating at a higher load with a minimum fuel consumption of 1.33 kg/h, the lowest BSFC of 0.243 kg/kWh, and second in BTE values at 21.16%. The result revealed that the main parameters, which include actual and specific fuel consumption, and the thermal efficiency of PE biodiesel performed satisfactorily. Although there was a slight decrease in the total power delivered, the overall performance was comparable to petroleum diesel.

Indonesia has been blessed with excellent solar heat distribution, which can be used as renewable energy to heat water. Various technologies have been developed to utilize these inexhaustible thermodynamic resources, in the form of photons arrays, converted into concentrated heat for daily use, i.e., solar water heater. This renewable-based water heating system can provide significant energy efficiency, benefit the environment, and reduce energy use costs. This experimental study attempts to harvest the energy from the sun using a cylindrical through collector (CTC) type solar concentrator. The CTC was made of the solar reflective film (SRF) affixed to concentrator collector surfaces which was then mounted on an adjustable angle frame of the concentrator collector support. The heat generated from the concentrator was stored in water, and phase change material is embedded in the system to retain the heat longer. The research was carried out in Langsa City, Aceh, Indonesia. The results showed that water heaters using CTC systems could produce 16 L of hot water retained at 40–60 °C for four hours. With the addition of beeswax, the water temperature of the same capacity can be maintained at 40–60 °C for around 5 h. This technology demonstrated an excellent result that produces as much as 60 L of water per day, increasing solar thermal energy efficiency. This technology presented a great potential for replication or even for further development on an industrial scale.

Currently Aceh has 458,616 hectares of oil palm plantation with production of 1,077,099 tons, processed in 40 Palm Oil Mill and produces about 607 thousand Palm Oil Mill Effluent (POME). POME is known to produce biogas which consists of methane which is Green House Gas (GHG) that can be recognized to cause global warming. The entire processing plant uses only a lagoon system in wastewater treatment, usually the first anaerobic stage followed by a facultative treatment. Both of these major palm oil wastes are renewable energy sources that can be utilized to generate electrical energy. In this study, a feasibility analysis of POME utilization has been conducted to generate electricity. Data on plant capacity, amount of wastewater produced, type of waste treatment owned by palm factory, waste treatment performance, and technical specifications of waste treatment. Collected from all Palm Oil Factory. Net present value, return rate and internal capital return are calculated. Based on the calculated value it has been found that the application of a biogas plant for power generation is economically feasible in the perspective of Aceh Province and the survival or economic attractiveness increases with increasing crop.