Developing bone scaffolds can greatly improve the patient’s quality of life by accelerating the rehabilitation process. In this paper, we studied the process of composite polycaprolactone supercritical foaming for tissue engineering. The influence of graphene oxide and reduced graphene oxide on the foaming parameters was studied. The structural and mechanical properties were studied. The scaffolds demonstrated mechanical flexibility and endurance. The co-culturing and live/dead tests demonstrated that the obtained scaffolds are biocompatible. Different composite scaffolds induced various surface cell behaviors. The experimental data demonstrate that composite foams are promising candidates for in vivo medical trials.

High-pressure electron paramagnetic resonance (EPR) was used to measure translational diffusion coefficients (D_tr) of a TEMPONE spin probe in poly(D,L-lactide) (PDLLA) and swollen in supercritical CO₂. D_tr was measured on two scales: macroscopic scale (>1 μm), by measuring spin probe uptake by the sample; and microscopic scale (<10 nm), by using concentration-dependent spectrum broadening. Both methods yield similar translational diffusion coefficients (in the range 5–10 × 10⁻¹² m²/s at 40–60 °C and 8–10 MPa). Swollen PDLLA was found to be homogeneous on the nanometer scale, although the TEMPONE spin probe in the polymer exhibited higher rotational mobility (τ_corr = 6 × 10⁻¹¹ s) than expected, based on its D_tr. To measure distribution coefficients of the solute between the swollen polymer and the supercritical medium, supercritical chromatography with sampling directly from the high-pressure vessel was used. A distinct difference between powder and bulk polymer samples was only observed at the start of the impregnation process.

Aqueous two-phase extraction (ATPE) is a green separation technique which uses mixtures of water and environmentally benign polymers such as polyethylene glycol (PEG) as solvents. One of the challenges in implementing this extraction on an industrial scale is finding a suitable method for the isolation of target compounds from water-polymer solutions after the extraction, without diminishing ecological benefits of the method. In this paper, we propose using another green separation technique, supercritical fluid extraction (SFE), for the back-extraction of low molecular weight medium polarity compounds from ATPE solutions. Experiments with two model compounds, caffeine and benzoic acid, showed principal applicability of SFE for this task. Pressure (100–300 bar) and temperature (35–75 °C) of supercritical carbon dioxide play a major role in defining extraction capability. Extraction ratios of 35% for caffeine and 42% for benzoic acid were obtained at high fluid pressure and moderate temperature at 1:6 volume phase ratio. That gives an estimation of 10–20 theoretical steps required for complete exhaustive extraction from the ATPE solution, which is readily achievable in standard counter-current column SFE. Combining these two green methods together not only serves as an environmentally friendly method for the isolation of valuable low molecular weight compounds from diluted water solutions, but also allows for simple, energy effective recuperation of ATPE solvents.