A high-throughput layered decoder for quasi-cyclic (QC) low-density parity-check (LDPC) codes is required for communication systems. The preferred way to improve the throughput is to insert pipeline stages and increase the operating frequency, which suffers from pipeline conflicts at the same time. A priority-based layered schedule is proposed to keep the updates of log-likelihood ratios (LLRs) as frequent as possible when pipeline conflicts happen. To reduce pipeline conflicts, we also propose double update queues for layered decoders. The proposed double update queues improve the percentage of updated LLRs per iteration. Benefitting from these, the performance loss of the proposed decoder for the fifth generation (5G) new radio (NR) is reduced from 0.6 dB to 0.2 dB using the same quantization compared with the state-of-the-art work. As a result, the throughput of the proposed decoder improved up to 2.85 times when the signal-to-noise ratio (SNR) was equal to 5.9 dB.

We experimentally demonstrate on-chip modal crosstalk mitigation over two mode-division multiplexing (MDM) integrated circuits supporting four and eleven waveguide modes employing low-coherence matched detection. 30-Gbaud 8-PSK mode-multiplexed signal is successfully transmitted over the circuits without using multiple-in-multiple-output (MIMO) processing under a maximum modal crosstalk of 10 dB. Ten-mode-multiplexed on-chip transmission achieves a total capacity of 900 Gbit/s. This work shows the feasibility of using high-order modes in on-chip MDM transmission for future high-capacity optical interconnects.

A clock-gating-based energy-efficient scheme is proposed, for the first time, for applications in optical network units (ONUs) accommodated by orthogonal frequency division multiplexing passive optical networks (OFDM-PONs) based on intensity modulation and direct detection (IMDD). In the operation of a conventional downlink OFDM-PON, each ONU has to perform the demodulation in the physical layer for all the received OFDM frames, regardless the received frames belong to the ONU or not. To improve the ONU's energy consumption efficiency, in this paper, frame identification and clock control modules are introduced into each ONU, where the former is to distinguish whether a received frame belongs to the ONU or not, and the latter is to control the operating clock of the OFDM demodulation module according to the frame identification output. As a result, when non-local frames arrive, the operating clock is set to a low value by the clock control module to deactivate the OFDM demodulation module in order to avoid unnecessary power consumption of the module. Experiments are undertaken in a real-time IMDD OFDM-PON platform, and measured results show that 51% energy consumption of a FPGA chip embedded in the ONU can be saved compared with its conventional counterpart for downlink unicast scenarios.

Integrating the graded index (GRIN) waveguide with the 2-D inversely-tapered waveguide, a new design of spot size converter (SSC) has been proposed to couple the light beam between the cleaved single-mode fiber (SMF) and the silicon (Si) wire waveguide on the silicon-on-insulator (SOI) platform. The device demonstrates a low coupling loss of 0.27 dB when it is coupled to a cleaved SMF. The polarization-dependent loss (PDL) is less than 0.25 dB, and the 1-dB alignment tolerance is about −2.0~2.0 µm for both vertical and horizontal directions. At the same time, the starting tip width of the tapered waveguide is kept at the level of the lithography limitation at the current commercial silicon photonics fab. This integrated SSC could be an improved design for reducing the coupling loss between the cleaved SMF and the Si waveguide.

A 2 μm wavelength band spot size converter (SSC) based on a trident structure is proposed, which is coupled to a lensed fiber with a mode field diameter of 5 μm. The cross-section of the first segment of the tapered waveguide structure in the trident structure is designed as a right-angled trapezoidal shape, which can further improve the performance of the SSC. The coupling loss of the SSC is less than 0.9 dB in the wavelength range of 1.95~2.05 μm simulated by FDTD. According to the experimental results, the lowest coupling loss of the SSC is 1.425 dB/facet at 2 μm, which is close to the simulation result. The device is compatible with the CMOS process and can provide a good reference for the development of 2 μm wavelength band integrated photonics.

At 2 µm wavelengths (149.9 THz), hollow-core photonics band gap fibers have higher light power damage thresholds, stable polarization states, and lower losses of 0.1 dB/km. Additionally, a thulium-doped fiber amplifier can provide a gain of >35 dB. Specifically, an indium-rich InGaAs photodetector shows a naturally higher photoresponsivity at 2 µm wavelengths than the C-band. Therefore, using tunable photo-generated microwave technology at 2 µm wavelengths could achieve higher photo-to-electric power conversion efficiencies for higher RF output power applications using the same method at the same frequency. Here, a double sideband with the carrier suppression modulation method was experimentally applied on 2 µm wavelengths to generate tunable and stable microwave carriers. Comparison experiments were also applied on the 1.55 µm (193.4 THz)/1.31 µm wavelengths (228.8 THz) based on the same indium-rich InGaAs photodetector. Through normalization on the wavelength-corresponded squared external quantum efficiency to visualize the photo-to-electric power conversion efficiency at different wavelengths under the same input optical signal power, the ratio between the results at 2 µm wavelengths and C/O-band is abstracted as 1.31/1.98, approaching theoretical estimations. This corresponds to a power conversion efficiency increasement of ~1.16 dB/~2.98 dB. To our knowledge, this is the first study on 2 micron wavelengths that proves the corresponding high efficiency power conversion property.