In this correspondence, useful measurement results of the propagation channel characteristics in an intra-wagon environment at millimeter wave (mmWave) frequencies are presented. The measurements were collected inside an underground convoy from 25 to 40 GHz in the frequency domain. A broadband radio over fiber (RoF) link was used in order to avoid the high losses introduced by cables at these frequencies, thus allowing long distances between the transmitter and receiver antennas. Values of the path loss exponent and delay spread are reported at the potential 26, 28 and 38 GHz bands to deploy the future fifth-generation (5G) systems. These results allow us to have a better knowledge of the path loss and time dispersion characteristics of the propagation channel in this particular environment, characterized by rich-scattering with long delays.
Millimeter wave (mm-wave) frequencies have been proposed to achieve high capacity in 5G communications. Although meaningful research on the channel characteristics has been performed in the 28-, 38-, and 60-GHz bands in both indoor and short-range scenarios, only a small number of trials (experiments) have been carried out in other mm-wave bands. The objective of this paper is to study the viability and evaluate the performance of the 94-GHz frequency band for MIMO-OFDM transmission in an indoor environment. Starting from a measurement campaign, the performance of MIMO algorithms is studied in terms of throughput for four different antenna configurations.
15 March 2012 in IEEE Antennas and Wireless Propagation Letters
It has been previously shown that communications in tunnel environments can be improved by using multiple-input-multiple-output (MIMO) techniques, despite the small angular spread of the rays. However, narrowband transmission was always assumed to fulfill the flat channel hypothesis. The objective of this letter is to generalize these previous works to the case of a wideband communication, i.e., when the transmission bandwidth is much larger than the coherence bandwidth of the channel. Performances of MIMO combined with orthogonal frequency division multiplexing (MIMO-OFDM) are studied in terms of bit error rate and considering either space-time coding or spatial multiplexing. Transfer matrices of the channel measured in a straight arched tunnel are introduced in the software used for simulating the communication link.
26 August 2022 in IEEE Transactions on Intelligent Transportation Systems
Metro and railway systems are one of the most used transportation systems for people in almost all countries. Nevertheless, the access to high throughput wireless services is still very limited inside the wagons (cars). A deep analysis of the wireless channel inside wagons is needed to deploy new efficient and high throughput networks as the ones provided by fifth-generation (5G) systems. Although several works have analyzed the intra-wagon channel, some limitations are usually present: only certain user equipment-access point situations were considered, the number of studied propagation mechanisms was limited, and only some channel parameters were extracted. For these reasons, in this work the wireless channel in an intra-wagon environment is thoroughly analyzed using simulations performed with a ray-tracing tool calibrated and validated with wideband measurements. Thanks to the accurate ray-tracing tool the main replicas are identified in different typical user equipment-access point positions; the contribution of each propagation mechanism to the total power is extracted; and the angular spread in azimuth and elevation for the direction of arrival and departure are obtained. This analysis is performed in the frequency range from 25 to 40 GHz, where spectrum for several 5G bands has been already allocated.
6 January 2014 in IEEE Antennas and Wireless Propagation Letters
Previous works have shown that multiple-input-multiple-output techniques such as space-time block code applied to tunnel environments present better performances than a single-input-single-output transmission, despite the small angular spread of the rays in this environment. Nevertheless, taking the guiding effect of the tunnel into account, one can wonder whether the simplest diversity schemes, in terms of complexity and implementation, may be a challenging solution, at least if compact arrays are used. The objective of this letter is thus to compare the performances of transmission schemes using diversity either at both ends of the link or at only the receiving side. The determination of symbol error rate is based on Monte Carlo simulations using channel matrices measured in a straight arched tunnel.
20 September 2010 in IEEE Antennas and Wireless Propagation Letters
The performance of multiple-input-multiple-output (MIMO) systems is strongly affected by the properties of the channel matrices. In tunnels, despite the small angular spreads of the rays, it has already been shown that the average mutual information can be strongly enhanced using MIMO rather than single-input-single-output (SISO). However, limited information is available on the improvement of the bit error rate (BER), assuming a fixed throughput and transmitted power. In this letter, starting from measured transfer matrices in a straight arched tunnel, MIMO performances based on VBLAST or QSTBC algorithms are compared to those of a SISO link. Furthermore, the use of polarization diversity is also studied.