In order to establish the prediction model of radar equipment in multisource complex electromagnetic environment, the blocking effect and false alarm interference effect caused by single-frequency CW (continuous wave) electromagnetic interference on typical radar equipment are studied. Taking a certain sweep radar as the research object, the equivalent injection test of EMI (electromagnetic interference) is carried out. Based on the theory of radar front door coupling, the interference mechanism of EMI to radar receiver RF front end is revealed, and the variation law of blocking target and false alarm target level is analyzed. The results show that, under the single-frequency CW-EMI, the target echo level decreases with the increase of the interference field strength, and the false alarm level increases with the increase of the interference field strength. The blocking jamming sensitive bandwidth is about , and the false alarm jamming sensitive bandwidth is about .
8 December 2022 in IEEE Transactions on Electromagnetic Compatibility
In order to evaluate the viability of frequency equipment in complex electromagnetic environment, the electromagnetic radiation effect evaluation model of random noise is established based on the analysis of the blocking effect mechanism of frequency equipment. Through MATLAB calculation, the corresponding relationship table between the ratio of the critical interference field strength effective value of single frequency continuous wave and sinusoidal amplitude modulation wave and the key parameters of the model is given, and the prediction method of noise electromagnetic interference of frequency equipment is proposed. Taking a Beidou navigation receiver as the test object, the accuracy of the noise electromagnetic radiation blocking effect model is verified by single frequency continuous wave, random noise and narrowband noise electromagnetic radiation blocking effect test, and the maximum error is only 1.51 dB, which indicates that the model and prediction method proposed in this article can accurately evaluate and predict the electromagnetic radiation interference of random noise.
With the increasing complexity of the electromagnetic environment, existing electronic systems and various equipment are greatly threatened. The study of the assessment of the effects of the electromagnetic environment has attracted more and more attention in the academic field and industry. In this review, the definition of the electromagnetic environmental effects assessment could be classified into two categories: objective and subjective equipment electromagnetic environmental effect assessments. Studies on both are comprehensively reviewed. The electromagnetic environmental effect assessment models are described and analyzed. The effects evaluation models mainly calculate the electromagnetic environmental effect index by various weighting, probability, and normalized interference level methods. However, each proposed model has certain limitations, so it cannot deal with all the electromagnetic interference effects. Therefore, a comprehensive evaluation model for complex electromagnetic environmental effects has not yet been established. Recent studies have shown that neural networks can be used to improve the adaptability of evaluation models in electromagnetic environments. The evaluation result of the normalized interference level method is more consistent with the actual work efficiency. The combination of the two can unify the objective and subjective assessments, which is of great significance to the improvement of the consistency and accuracy of the results of the effects evaluation of the electromagnetic environment. Accordingly, challenges for future research are revealed, which plays a vital role in the development of electromagnetic environmental effects research and provides a reference for researchers.
10 November 2021 in IEEE Transactions on Electromagnetic Compatibility
To identify and improve the electromagnetic compatibility of a global navigation satellite system (GNSS) receiver under a complex electromagnetic environment, the blocking effects of single-frequency and out-of-band dual-frequency electromagnetic radiation (EMR) on a GNSS receiver were experimentally analyzed. This study is the first to investigate second-order intermodulation second-order intermodulation low-frequency blocking (SILB) interference which was newly discovered in our tests. The mechanism of the SILB effect was analyzed, and two key parameters were identified. The SILB interference factor and the relative value of the low-frequency interference level were introduced to establish a model predicting SILB effects. The method of determining the parameters, the modeling process, and the results are discussed in this article on the basis of both theoretical derivations and experimental measurements. A GNSS receiver was used as the equipment under test to verify the model. Notably, the results demonstrated that the threshold for SILB was approximately 30 dB lower than that for out-of-band single-frequency interference. The model proposed in this article accurately evaluated and predicted the SILB interference.
17 July 2023 in IEEE Transactions on Antennas and Propagation
To solve the problem of inaccurate blocking effects evaluation caused by inconsistent models in the complex electromagnetic environment, the general evaluation model of multi-frequency electromagnetic radiation and that of noise electromagnetic radiation were constructed based on time-delay characteristic analysis of circuit response. After analyzing the cross-linking relationship of the amplitude-sensitive, the insensitive, and the root mean square(RMS) sensitive models, a comprehensive evaluation model involving the three models is proposed. Additionally, the experiment was carried out on a navigation receiver to verify the model performance. The evaluation error is less than 1dB when the equipment is sensitive to multi-frequency electromagnetic radiation interference, while the error is less than 2.2 dB when the equipment is insensitive. The evaluation error is less than 1.5 dB under noise electromagnetic radiation interference. The experiment results have verified the adaptability of the proposed models in a complex electromagnetic environment, which is beneficial for improving the evaluation accuracy and simplifying the engineering application.
21 June 2022 in IEEE Transactions on Electromagnetic Compatibility
Due to the insensitive blocking effect on frequency equipment, the current effect evaluation model based on the third-order power series expansion is disabled to the insensitive blocking effect evaluation under multi-frequency electromagnetic radiation. We adopt the fifth-order power series expansion to analyze the insensitive blocking interference effect. In addition to revealing the mechanism of the insensitive blocking effect under multi-frequency electromagnetic radiation, we also build an improved effect evaluation model in this research. It defines the effect evaluation index. Subsequently, a ranging radar and a communication radio station are employed to verify the effectiveness of the proposed effect evaluation model separately. The results show that the proposed model can be applied to the electromagnetic radiation effect evaluation, regardless of whether the multi-frequency insensitive jamming effect exists on tested equipment or not. All effect evaluation indexes of the new model are smaller than that of the previous model based on the third-order power series expansion method. The absolute value of relative errors could be less than 1 dB. Not only is the theoretical analysis result of the multi-frequency insensitive blocking effect mechanism verified, but also the problem of poor universality of the current electromagnetic radiation effect evaluation model is figured out.