Zubair Ahmed

Zubair Ahmed

Auto-generated profile, based on publicly available information

Zubair Ahmed

Department of Engineering Science, University of Oxford, Oxford, U.K.

Research Focus & Metrics

Academic Career Length

8Years (2019-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
11 February 2020 in IEEE Photonics Technology Letters
Verified
Journal Article
Closed access
ZAZubair Ahmed
Zubair Ahmed
RSRavinder Singh
Ravinder Singh
WAWajahat Ali
Wajahat Ali
GFGrahame Faulkner
Grahame Faulkner
DODominic O'Brien
Dominic O'Brien
SCSteve Collins
Steve Collins
The growing demand for wireless communications services means that RF systems are increasingly unable to support user’s requirement. Consequently, there is a growing interest in using visible light communication (VLC), including interest in sensitive VLC receivers. Since they have the potential to detect single photons, silicon photomultipliers (SiPMs) could potentially be used to create the most sensitive possible VLC receivers. In this paper, results of experiments to determine the optimum bias voltage and dynamic range of an off-the-shelf SiPM are reported. Results are then presented which show that in 500 lux of ambient light this receiver supports data rates of more than 2 Gbps with a bit-error-rate (BER) of 10–3.

19 June 2019 in Journal of Lightwave Technology
Verified
Journal Article
Closed access
LZLong Zhang
Long Zhang
HCHyunchae Chun
Hyunchae Chun
ZAZubair Ahmed
Zubair Ahmed
GFGrahame Faulkner
Grahame Faulkner
DODominic C. O'Brien
Dominic C. O'Brien
SCSteve Collins
Steve Collins
A silicon photomultiplier (SiPM) could be used to create visible light communications receivers whose sensitivity is determined by shot-noise. However, its finite output pulse width will limit its bandwidth and its recovery time and dark count rate could limit its sensitivity. In this paper, a method of accurately determining the signal levels needed to transmit data in a shot-noise limited system using PAM is described. In addition, a method of estimating the additional power needed to use equalisation to overcome inter-symbol interference caused by the finite output pulse width of SiPMs is described. The best way to achieve more than 1 Gbps with this type of receiver and how to select the best available SiPM as a receiver are then discussed.

30 March 2021 in IEEE Photonics Technology Letters
Verified
Journal Article
Closed access
WMWilliam Matthews
William Matthews
ZAZubair Ahmed
Zubair Ahmed
WAWajahat Ali
Wajahat Ali
SCSteve Collins
Steve Collins
A relationship between irradiance and the current needed to maintain the bias voltage applied to a silicon photomultiplier (SiPM) is shown to agree with experimental data. In addition to showing the saturation of the SiPMs response this relationship can be used to determine the power consumed by an SiPM. In addition, results are presented which show that, because of its higher maximum photon count rate, a 30020 SiPM can achieve a bit error rate (BER) of 10 -3 at a data rate of 3.45 Gbits/s.

19 March 2021 in IEEE Photonics Technology Letters
Verified
Journal Article
Closed access
WMWilliam Matthews
William Matthews
WAWajahat Ali
Wajahat Ali
ZAZubair Ahmed
Zubair Ahmed
GFGrahame Faulkner
Grahame Faulkner
SCSteve Collins
Steve Collins
Results of an investigation into the performance of a wide field of view silicon photomultiplier (SiPM) receiver under ambient light are reported. During these investigations a new form of inter-symbol interference (ISI) was discovered, which can be attributed to saturation of the SiPM. This new form of ISI means that using decision feedback equalization (DFE) improves the receiver's performance at low data rates.

1 February 2021 in IEEE Access
Verified
Journal Article
Open access
CHCuiwei He
Cuiwei He
ZAZubair Ahmed
Zubair Ahmed
SCSteve Collins
Steve Collins
In this article, the performance of a new time domain signal pre-equalization method for use with optical orthogonal frequency division multiplexing (OFDM) and a silicon photomultiplier (SiPM) based receiver is studied. A SiPM contains a large array of microcells and each microcell is able to detect single photons. Therefore, a SiPM can be used to create arguably the most sensitive optical receiver, which can detect light intensity signals by counting the number of arriving photons within each signal sampling period. However, each photon detection triggers an avalanche-and-quenching process and the related microcell becomes inactive for a recovery time of several nanoseconds. Consequently, any photons arriving during this period cannot be detected. This effect can cause a non-linear distortion of the received signal and, when the OFDM sampling period is short, also introduces interference between signal samples. In this article, a new signal pre-equalization method is specifically designed to compensate for the impact of the finite recovery time. In this method, the number of active microcells during the transmission of each OFDM signal sample is first estimated. Then, the amplitude of the time domain signal sample is pre-adjusted based on the predicted fraction of microcells that are active. Using this approach, the negative impacts of the recovery time of the microcells are significantly reduced. The results that are presented show that when this new form of pre-equalization is used the bit error rate (BER) performance of the system is improved for a wide range of irradiance levels.

28 September 2021 in IEEE Photonics Technology Letters
Verified
Journal Article
Closed access
WAWajahat Ali
Wajahat Ali
ZAZ. Ahmed
Z. Ahmed
WMW. Matthews
W. Matthews
SCSteve Collins
Steve Collins
Fluorophore doped plastic optical fibers can be used to create optical concentrators in receivers for visible light communications, that also act as wide field of view filters. Increasing the length of these fibers allows them to collect more of the signal from the transmitter, however, it can also reduce the bandwidth of the fiber. Results are presented from 3 different lengths of fiber which show that the best length of a fluorescent fiber depends upon the data rate. However, a simple calculation results in a length that is a good choice for a range of OOK data rates.