Frame structures equipped with steel plate shear walls (SPSWs) have been widely used in high-rise buildings due to their good seismic performance. In this study, the strip model and combined strip model were used to analyze the performance of SPSWs. Furthermore, an improved genetic algorithm (IGA) was established to optimize the steel frame for 5, 10, and 20 stories. For each layer, layout optimization was conducted to determine the best configurations of the SPSWs, and two cases of size optimizations of conventional SPSW configurations in the frame were conducted. Results indicate the following: (i) the total weight of the five-story steel frame of layout optimization to determine the best SPSW configuration was approximately 10% lighter than those of the size optimization of conventional SPSW configurations, and this proportion gap expanded to approximately 15–25% for the 10-story and 20-story steel frames; (ii) the steel frame weight could be significantly reduced if the average percentages of story shear resisted by web plates are increased; and (iii) in the steel frame of layout optimization, the structural elements, especially the plate elements, were better utilized than those of size optimization when their inter-story drift ratios met the specification requirements. These results highlight the prominent performances of some important indicators of the design of an SPSW system with the layout optimized using IGA.
The welds of T-joints are prone to fatigue cracking owing to stress concentrations and welding residual stresses. Previous studies investigated the crack propagation rate using numerical simulations; however, most employed two-dimensional models and ignored the effect of residual stresses. In this study, reliable temperature and residual stress fields were obtained through numerical simulations and verified experimentally. The effects of residual stresses on crack propagation were then investigated under different loading conditions. The residual stress field caused the direction of crack propagation to shift towards the web and accelerated the crack propagation speed with increasing displacement loading.
A steel plate shear wall (SPSW) is a useful component for resisting lateral action. To improve the performance of frame columns, some studies focus on a two-side connected SPSW, in which the wall plate is not connected with the frame columns. However, few studies conducted on a two-side connected SPSW consider the effect of frame constraints or the connections between the infill plates and frame beams. In this study, by using finite element modeling (FEM), two unstiffened SPSW models with two-side fixed connections and six unstiffened SPSW models with two-side bolt connections were simulated. Their performance under the presence of out-of-plane frame beam flange constraints and different numbers of bolts between the infill plates and frame beams was analyzed. The mechanical performances such as hysteretic behaviors, the capacity of energy dissipation and the out-of-plane deformation of the members were investigated by applying monotonic and cyclic loading. The results revealed that non-negligible deformation would be generated at the lateral border of the bolt connections and that the out-of-plane deformation of the frame could be significantly affected by constraints. These findings can guide the engineering design of SPSWs in the future.
Two types of lateral resistance structural systems, namely unstiffened steel plate shear walls (USPSWs) and stiffened steel plate shear walls (SSPSWs), are typically used in high-rise structures. Numerous experimental and numerical studies have been conducted on the structural performance of SSPSWs. However, few studies have been conducted to investigate the effect of column flexural stiffness on SSPSW systems. In this study, an analysis and numerical investigation of SSPSWs with variable column flexural stiffnesses was performed. The hysteretic performance, secant stiffness reduction and energy dissipation of SSPSWs with four column flexural stiffnesses were investigated. The column flexural stiffness reduction in the USPSWs and SSPSWs did not negatively influence the overall performance of drift ratios up to 2.5%. Moreover, the infill plates of the USPSWs and SSPSWs could achieve the ultimate strengths similar to the theoretical values despite the column not satisfying the minimum flexural stiffness requirements from CSA S16-09 and PEER/ATC72-1, which indicated that these requirements could be conservative.