We report an electro-absorption modulator integrated with a distributed feedback Bragg laser fabricated by butt-joint technology. The lasing wavelength of the EML laser was 1311.71 nm, the output power was 10.04 mW when the current of the DFB section was 100 mA, the side-mode suppression ratio was greater than 50 dB, and the small-signal bandwidth was 29.40 GHz when the bias voltage of the modulator was −2 V. A 50 Gb/s data transmission over a single-mode fiber of up to 10 km was realized, which could be used as a light source for 50 G passive optical network systems.

The optical feedback tolerance (OFT) of a distributed Bragg reflector (DBR) laser was investigated experimentally. The static and modulation performance of the DBR laser under optical feedback was examined by evaluating its relative intensity noise (RIN) and bit error rate (BER). It is shown that the OFT of the DBR laser is closely related to its peak wavelength detuning relative to the Bragg wavelength. A high tolerance to optical feedback was demonstrated, both in the continuous wave (CW) and the direct modulation (DM) states, when the DBR laser was red-detuned relative to the Bragg wavelength. The excess RIN induced by optical feedback was well suppressed to a level of −140 dB/Hz at a feedback level of −9 dB in the CW state. In a 10 Gbps direct modulation state, bit error rates (BER) below 1 × 10⁻⁹ and 3 × 10⁻⁷ were obtained under a feedback level of −15 dB and −9 dB, respectively, for the case of back-to-back transmission. After 20 km fiber transmission, the BER still maintained below 1 × 10⁻⁷ under a feedback level of −15 dB, with a power penalty of less than 1 dB.