In this study, the energy deposited at the welding interface was controlled by changing the stand-off between the flyer and base plates. Pure titanium (TP 270C) and duplex stainless steel (SUS 821L1) were welded under 5- and 15-mm stand-offs, respectively. When the stand-off was 5 mm, the average wavelength and average amplitude of the welding interface were 271 and 61 μm, respectively; at 15 mm stand-off, the average wavelength and average amplitude of the welding interface were 690 and 192 μm, respectively. The differences between the two welding conditions were compared using a tensile test, fracture analysis, a 90° bending test, Vickers hardness, and nanoindentation related to the mechanical properties of materials. The experimental results indicated that the sample with a 5-mm stand-off had better mechanical properties.
30 August 2024 in Journal of Materials Research and Technology
In this study, a series of nano-TiO2 composite materials, including nano-TiO2, nano-SnO2/TiO2, nano-SiO2/TiO2, and nano-Fe2O3/TiO2, were successfully synthesized via the gaseous detonation method. Comprehensive characterization of the synthesized samples was carried out through X-ray diffraction (XRD), transmission electron microscopy/high-resolution TEM (TEM/HRTEM), scanning electron microscopy/energy-dispersive X-ray spectroscopy (SEM/EDS), Brunauer-Emmett-Teller (BET) method, and Fourier transform infrared (FTIR) analysis, which unveiled the significant influence of precursor types on the microstructure of the composite materials. Specifically, the incorporation of Sn4+ promoted the transformation of TiO2 to the rutile phase, reducing particle sizes from 25 to 19 nm and increasing the specific surface area from 44 to 86 m2/g. In contrast, the introduction of SiO2 impeded the rutile phase formation, leading to a marked reduction in particle size to 14 nm and an enhancement of the specific surface area to 104 m2/g. Furthermore, the presence of Fe3+ promoted the formation of the rutile phase and enabled particle growth to 44 nm. These findings not only deepen the understanding of structural control in the synthesis of nano-TiO2 composite materials via the gaseous detonation method but also highlight the critical role of precursor selection in determining the properties of the resulting materials.
18 May 2017 in IOP Conference Series: Earth and Environmental Science
Munroe effect has been more and more used in blasting engineering and most assembling energy technologies use a shaped charge device. In this paper, a new method is used to achieve detonation wave collision by detonating cord initiation system. A numerical simulation using LS-DYNA on detonation wave propagation and collision process caused by different initiation forms is implemented. Numerical results show that peak pressure by this new method can reach 2.42 times than the traditional method, and the growth of specific impulse at the explosive bottom is 49% compared to early results. Based on this numerical simulation, an experiment of explosive-determination of power be implemented, the experiment result can verify the simulation result well.
19 April 2024 in The International Journal of Advanced Manufacturing Technology