Renewable energy systems are technologies that can generate electricity from solar, wind, hydroelectric, biomass, and other renewable energy resources. This research project aims to find the best renewable energy technology combinations for several scenarios in Malaysia. The strategies are analysed by evaluating the investments in the renewable energy systems in each of the decided scenarios in Malaysia, Pekan, Pahang and Mersing, Johor, using HOMER Pro software. The finding shows that the PV–wind hybrid system has a better net present cost (NPC) than the other systems for both scenarios, which are USD −299,762.16 for Scenario 1 and USD −642,247.46 for Scenario 2. The PV–wind hybrid system has 4.86-year and 2.98-year payback periods in Scenarios 1 and 2. A combination of RE technologies yielded fewer emissions than one kind alone. The PV–wind hybrid system provides a quicker payback period, higher money savings, and reduced pollutants. The sensitivity results show that resource availability and capital cost impact NPC and system emissions. This finding reveals that integrated solar and wind technologies can improve the economic performance (e.g., NPC, payback period, present worth) and environmental performance (e.g., carbon dioxide emissions) of a renewable energy system.

As the world shifts towards a more sustainable future, solar energy has emerged as a preeminent and economically feasible alternative to traditional energy sources, gaining widespread adoption. This study presents a reversed circular flow jet impingement (RCFJI) which aims to improve the performance of a bifacial PVT collector. An indoor experiment using a solar simulator to assess the energy, exergy, and economic efficiency of a RCFJI bifacial PVT collector. The study was carried out using a solar irradiance ranging from 500-900W/m2 and a mass flow rate between 0.01-0.14 kg/s. Energy performance-wise, the highest photovoltaic efficiency achieved was 11.38% at solar irradiance of 500 W/m2, while the highest thermal efficiency achieved was 61.4% under 900 W/m2, both obtained at 0.14 kg/s mass flow rate. Regarding exergy performance, the highest photovoltaic exergy obtained was 47.27 W under 900 W/m2 at 0.14 kg/s, while the highest thermal exergy was 9.67 W at 900 W/m2 at 0.01 kg/s. Overall, higher solar irradiance is more desirable for energy and exergy performance. Meanwhile, economic point of view, lower solar irradiance is preferable. Based on the findings, the optimal mass flow rate was 0.06 kg/s.

A relatively new technology, a hybrid photovoltaic thermal (PVT) solar collector, allows for producing electrical and thermal energy. However, the module heats up more when exposed to sunlight thanks to the PVT collector's incorporation, reducing its efficiency. Consequently, lowering the operating temperature is crucial for maximizing the system's effectiveness. This research aims to create a photovoltaic thermal phase change material (PVT-PCM) solar collector and evaluate its energy performance through a controlled laboratory environment. Two different PVT collector designs, one using water and the other using a phase change material (PCM), were evaluated using a spiral flow configuration. Under a sun simulator, the PVT solar collector was subjected to 400 W/m2, 600 W/m2, and 800 W/m2 of solar irradiation at three different mass flow rates. The results showed that under 800 W/m2 of solar irradiation and 0.033 kg/s mass flow rate, the collector using water could only reach an overall maximum efficiency of 64.34 %, whereas the PVT-PCM configuration with spiral flow had the maximum performance, with an overall efficiency of 67.63%.