Zhakyp T. Karipbayev

Dr. Zhakyp T. Karipbayev


Research Focus & Metrics

Academic Career Length

13Years (2014-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
11 January 2022 in Physica Status Solidi (b)
Verified
Journal Article
Closed access
PDF file
ZKZhakyp T. Karipbayev
Zhakyp T. Karipbayev
KKKuat Kumarbekov
Kuat Kumarbekov
IMIlze Manika
Ilze Manika
ADAlma Dauletbekova
Alma Dauletbekova
AKArtem L. Kozlovskiy
Artem L. Kozlovskiy
Anatoli I PopovAnatoli I Popov
Anatoli I Popov

1 November 2018 in Nuclear Instruments and Methods in Physics Research Section B: Beam Interactions with Materials and Atoms
Verified
Journal Article
Closed access
VLV. Lisitsyn
V. Lisitsyn
LLL. Lisitsyna
L. Lisitsyna
Alma DauletbekovaAlma Dauletbekova
Alma Dauletbekova
MGM. Golkovskii
M. Golkovskii
ZKZhakyp T. Karipbayev
Zhakyp T. Karipbayev
EPE. Polisadova
E. Polisadova

29 December 2022 in Materials
Verified
Journal Article
Open access
PDF file
AAAleksei Almaev
Aleksei Almaev
VKViktor Kopyev
Viktor Kopyev
VNVadim Novikov
Vadim Novikov
ACAndrei V. Chikiryaka
Andrei V. Chikiryaka
NYNikita Yakovlev
Nikita Yakovlev
Anatoli I PopovAnatoli I Popov
Anatoli I Popov
Indium tin oxide thin films were deposited by magnetron sputtering on ceramic aluminum nitride substrates and were annealed at temperatures of 500 °C and 600 °C. The structural, optical, electrically conductive and gas-sensitive properties of indium tin oxide thin films were studied. The possibility of developing sensors with low nominal resistance and relatively high sensitivity to gases was shown. The resistance of indium tin oxide thin films annealed at 500 °C in pure dry air did not exceed 350 Ohms and dropped by about 2 times when increasing the annealing temperature to 100 °C. Indium tin oxide thin films annealed at 500 °C were characterized by high sensitivity to gases. The maximum responses to 2000 ppm hydrogen, 1000 ppm ammonia and 100 ppm nitrogen dioxide for these films were 2.21 arbitrary units, 2.39 arbitrary units and 2.14 arbitrary units at operating temperatures of 400 °C, 350 °C and 350 °C, respectively. These films were characterized by short response and recovery times. The drift of indium tin oxide thin-film gas-sensitive characteristics during cyclic exposure to reducing gases did not exceed 1%. A qualitative model of the sensory effect is proposed.

1 June 2019 in Radiation Measurements
Verified
Journal Article
Closed access
SGSholpan Giniyatova
Sholpan Giniyatova
Alma DauletbekovaAlma Dauletbekova
Alma Dauletbekova
ZBZein Baimukhanov
Zein Baimukhanov
LULiudmila Ulasukova
Liudmila Ulasukova
AAAbdirash Akilbekov
Abdirash Akilbekov
ZKZhakyp T. Karipbayev
Zhakyp T. Karipbayev

4 July 2025 in Technologies
Verified
Journal Article
Open access
PDF file
AAAleksei Almaev
Aleksei Almaev
ZKZhakyp T. Karipbayev
Zhakyp T. Karipbayev
AKAskhat Kakimov
Askhat Kakimov
NYNikita Yakovlev
Nikita Yakovlev
OKOlzhas Kukenov
Olzhas Kukenov
Anatoli I PopovAnatoli I Popov
Anatoli I Popov
The use of CH4 as an energy source is increasing every day. To increase the efficiency of CH4 combustion and ensure that the equipment meets ecological requirements, it is necessary to measure the CH4 concentration in the exhaust gases of combustion systems. To this end, sensors are required that can withstand extreme operating conditions, including temperatures of at least 600 °C, as well as high pressure and gas flow rate. ZnGa2O4, being an ultra-wide bandgap semiconductor with high chemical and thermal stability, is a promising material for such sensors. The synthesis and investigation of the structural and CH4 sensing properties of ceramic pellets made from pure and Er-doped ZnGa2O4 were conducted. Doping with Er leads to the formation of a secondary Er3Ga5O12 phase and an increase in the active surface area. This structural change significantly enhanced the CH4 response, demonstrating an 11.1-fold improvement at a concentration of 104 ppm. At the optimal response temperature of 650 °C, the Er-doped ZnGa2O4 exhibited responses of 2.91 a.u. and 20.74 a.u. to 100 ppm and 104 ppm of CH4, respectively. The Er-doped material is notable for its broad dynamic range for CH4 concentrations (from 100 to 20,000 ppm), low sensitivity to humidity variations within the 30–70% relative humidity range, and robust stability under cyclic gas exposure. In addition to CH4, the sensitivity of Er-doped ZnGa2O4 to other gases at a temperature of 650 °C was investigated. The samples showed strong responses to C2H4, C3H8, C4H10, NO2, and H2, which, at gas concentrations of 100 ppm, were higher than the response to CH4 by a factor of 2.41, 2.75, 3.09, 1.16, and 1.64, respectively. The study proposes a plausible mechanism explaining the sensing effect of Er-doped ZnGa2O4 and discusses its potential for developing high-temperature CH4 sensors for applications such as combustion monitoring systems and determining the ideal fuel/air mixture.

1 November 2023 in Materials
Verified
Journal Article
Open access
PDF file
AUAbay Usseinov
Abay Usseinov
ZKZhakyp T. Karipbayev
Zhakyp T. Karipbayev
JPJuris Purans
Juris Purans
AKAskhat Kakimov
Askhat Kakimov
ABAizat Bakytkyzy
Aizat Bakytkyzy
Anatoli I PopovAnatoli I Popov
Anatoli I Popov
The synthesis of β-Ga2O3 ceramic was achieved using high-energy electron beams for the first time. The irradiation of gallium oxide powder in a copper crucible using a 1.4 MeV electron beam resulted in a monolithic ceramic structure, eliminating powder particles and imperfections. The synthesized β-Ga2O3 ceramic exhibited a close-to-ideal composition of O/Ga in a 3:2 ratio. X-ray diffraction analysis confirmed a monoclinic structure (space group C2/m) that matched the reference diagram before and after annealing. Photoluminescence spectra revealed multiple luminescence peaks at blue (~2.7 eV) and UV (3.3, 3.4, 3.8 eV) wavelengths for the synthesized ceramic and commercial crystals. Raman spectroscopy confirmed the bonding modes in the synthesized ceramic. The electron beam-assisted method offers a rapid and cost-effective approach for β-Ga2O3 ceramic production without requiring additional equipment or complex manipulations. This method holds promise for fabricating refractory ceramics with high melting points, both doped and undoped.