Carbon Fiber Reinforced Plastic (CFRP) shaft tube structure is widely applied in different fields, including aerospace, automotive, and wind power. Since CFRP shaft tube is often subjected to bending fatigue loads, it is of great significance to research its bending fatigue characteristics. Because of its unique advantages, such as a smaller size, lighter weight, and the outstanding ability to form a sensor network, the Fiber Bragg Grating (FBG) sensor is very applicable for health monitoring research of composite material structures. Taking the CFRP shaft tube under bending load as the research object, based on the theory of composite material mechanics and applying the research idea of combining simulation analysis and experiment, the fatigue life, residual stiffness, and fatigue damage evolution of CFRP tubes under three-point bending fatigue loading were studied. Moreover, the fatigue characteristics of CFRP tubes under different fatigue loading were analyzed. At the same time, the ultrasonic phased array was used to obtain the fatigue damage evolution rule by scanning and analyzing the damage to the CFRP shaft tube after different fatigue loading times. Through the application of the FBG sensors, the whole process of fatigue evolution of the CFRP shaft tube was fully monitored.
Hydrogen permeation parameters of PA12 were obtained through high-pressure hydrogen permeation experiments conducted under various temperature and pressure conditions. The temperature-dependent mechanism governing the hydrogen permeation behavior of PA12 was further examined using dynamic mechanical analysis (DMA). A multi-field coupled numerical model was established and validated against the experimental results. Based on the validated numerical approach, the hydrogen permeation behavior of a type IV hydrogen storage vessel with local reinforcement was investigated. The results show that both temperature and pressure have a significant influence on the hydrogen permeation performance of PA12. When the temperature is below the glass transition temperature () of PA12 (48.34 °C), the diffusion coefficient remains low, whereas temperatures above the led to a marked increase in the diffusion coefficient. In addition, the local reinforcement patch effectively prolongs the time required to reach steady-state permeation, reduces the hydrogen permeation flux before and after steady state, and enhances the overall resistance to hydrogen permeation of the type IV vessel. As the diffusion coefficient of the liner material increases, the hydrogen diffusion rate increases substantially, leading to greater hydrogen accumulation in the dome region and higher permeation levels both before and after steady state. These findings provide theoretical guidance and design references for optimizing the hydrogen-resistant performance of type IV hydrogen storage vessels.
Hydrogen storage vessels are critical components in hydrogen energy systems, and improving their manufacturing efficiency and structural performance is essential for next-generation Type IV vessel designs. Compared with conventional wet filament winding, towpreg dry filament winding offers higher efficiency, reduced environmental impact, and better adaptability to complex structures. In this study, key process parameters, including winding tension, heating temperature, and winding speed were systematically optimized using the tensile strength and interlaminar shear strength of NOL ring specimens as evaluation metrics. A response surface methodology (RSM) regression model was established to correlate process variables with mechanical properties, followed by multi-objective optimization using the non-dominated sorting genetic algorithm II (NSGA-II) and final parameter selection through the Technique for Order Preference by Similarity to Ideal Solution (TOPSIS) method. The results indicate that shear strength is primarily affected by heating temperature, whereas tensile strength is mainly governed by winding tension. The optimal parameter combination (79 N, 360 °C, and 11 m/min) yielded tensile and shear strengths of 2462.2 MPa and 64.4 MPa, respectively, with prediction errors below 0.5%. A 9 L Type IV hydrogen storage vessel manufactured under these conditions showed approximately 15.4% lower mass and about 17% higher gravimetric hydrogen storage efficiency than a comparable wet wound vessel.