This research presents a model of a utility‐scale photovoltaic unit (USPVU) enhanced with an embedded hybrid energy storage system (HESS), suitable for stability studies in transmission systems. The main goal of this model is the simultaneous provision of primary frequency control and dynamic grid support. The primary frequency control includes both droop response (achieved by the frequency sensitive mode [FSM] operation) and inertial response (IR). To obtain these grid support functions, the research designed a suitable voltage and frequency ( V – f ) control, which coordinates the photovoltaic (PV) maximum power point tracking control, HESS converter control, and PV inverter control. Firstly, a midterm assessment of energy requirements in the sized HESS, based on frequency data, validated the energy availability of the enhanced USPVU for primary frequency control, according to new prequalification rules for energy‐constrained units. Then, transient stability assessments were performed on a representative transmission system to check the performance of the added FSM and IR in USPVUs with dynamic grid support. The results of the frequency phenomena in the IEEE 39‐bus system showed that the enhanced USPVU shared primary frequency control responsibilities with the conventional generation. This was achieved with two criteria to dispatch and commit conventional units by USPVUs.

The installation of smart meters in smart cities to monitor streetlights (SLs) provides easy access to measurements of electrical variables and lighting levels, which improves the operation of installation. The use of smart meters in cities requires temporary high-resolution data to improve the energy efficiency (EE) of SLs. Long range (LoRa) is an ideal wireless protocol for use in smart cities due to its low energy consumption, secure communications, and long range indoors and outdoors. For this purpose, we developed a low-cost new system and successfully evaluated it by developing three devices, namely the measure and control device for street lights (MCDSL), lighting level measurement device (LLMD) and gateway LoRa network (GWLN), based on the Arduino open-source electronic platform. This paper describes the hardware and software design and its implementation. Further, an algorithm has been developed to enhance the energy efficiency of public lights using MCDSL, the energy efficiency for street lights (EESL) algorithm, that use the illumination level measured on the same set of SLs with a dynamic control, which assumed different lighting levels throughout the night, and adjusted luminous flux based on the traffic intensity of pedestrians. It sends the acquired data through the LoRa low-power wide-area-network (LPWAN) to the cloud.

Irrigation installations in cities or agricultural operations use large amounts of water and electrical energy in their activity. Therefore, optimising these resources is essential nowadays. Wireless networks offer ideal support for such applications. The long-range wide-area network (LoRaWAN) used in this research offers a large coverage of up to 5 km, has low power consumption and does not need additional hardware such as repeaters or signal amplifiers. This research develops a control and monitoring system for irrigation systems. For this purpose, an irrigation algorithm is designed that uses rainfall probability data to regulate the irrigation of the installation. The algorithm is complemented by checking the sending and receiving of information in the LoRa network to reduce the loss of information packets. In addition, two temperature and humidity measurement devices for LoRaWAN (THMDLs) and an electrovalve control device for LoRaWAN (ECDLs) were developed. The hardware and software were also designed, and prototypes were built with the development of the electronic board. The wide coverage of the LoRaWAN allows the covering of small to large irrigation areas.