To solve the problem that turbidity in water has a significant effect on the spectra of nitrate and reduces the accuracy of nitrate detection, a turbidity-compensation method for nitrate measurement based on ultraviolet difference spectra is proposed. The effect of turbidity on the absorption spectra of nitrate was studied by using the difference spectra of the mixed solution and a nitrate solution. The results showed that the same turbidity had different effects on the absorbance of different concentrations of nitrate. The change in absorbance due to turbidity decreased with an increase in the nitrate concentration at wavelengths from 200 nm to 230 nm, although this change was constant when the wavelength was greater than 230 nm. On the basis of this characteristic, we combined the residual sum of squares (RSS) and interval partial least squares (iPLS) to select wavelengths of 230–240 nm as the optimal modeling interval. Furthermore, the turbidity-compensation model was established by the linear fitting of the difference spectra of various levels of turbidity. The absorption spectra of the nitrate were extracted by subtracting the turbidity-compensation curve from the original spectra of the water samples, and the nitrate concentration was calculated by using a partial least squares (PLS)-based nitrate-prediction model. The experimental results showed that the average relative error of the nitrate predictions was reduced by 50.33% to 1.33% by the proposed turbidity-compensation method. This indicated that this method can better correct the deviation in nitrate’s absorbance caused by turbidity and improve the accuracy of nitrate predictions.
To overcome the retrieval problems in complex water, dual working wavelengths are required instead of a single wavelength in oceanic lidar. The wavelength optimization method of detecting chlorophyll a and Colored Dissolved Organic Matter (CDOM) absorption coefficient with a dual-wavelength lidar is studied in this paper. The inversion methods of chlorophyll a and CDOM absorption are developed based on the water absorption characteristics, which then lead to the inversion error equations. The effects of the wavelength on the inversion errors are studied. For the case in which λ1 and λ2 are both random, the errors are relatively small when λ1 is chosen between 420 and 560 nm and λ2 is selected under 420 nm. For the case in which λ1 is fixed at 532 nm, the errors generally decrease with decreasing λ2, with minimums around 300 and 356–360 nm under different water conditions. The wavelength optimization method discussed in this paper and the penetration depth criterion will be beneficial to the design of the dual-wavelength lidar.
Nitrate contamination in water sources poses a substantial environmental and health risk. However, accurate detection of nitrate in water, particularly in the presence of dissolved organic carbon (DOC) interference, remains a significant analytical challenge. This study investigates a novel approach for the reliable detection of nitrate in water samples with varying levels of DOC interference based on the equivalent concentration offset method. The characteristic wavelengths of DOC were determined based on the first-order derivatives, and a nitrate concentration prediction model based on partial least squares (PLS) was established using the absorption spectra of nitrate solutions. Subsequently, the absorption spectra of the nitrate solutions were subtracted from that of the nitrate-DOC mixed solutions to obtain the difference spectra. These difference spectra were introduced into the nitrate prediction model to calculate the equivalent concentration offset values caused by DOC. Finally, a DOC interference correction model was established based on a binary linear regression between the absorbances at the DOC characteristic wavelengths and the DOC-induced equivalent concentration offset values of nitrate. Additionally, a modeling wavelength selection algorithm based on a sliding window was proposed to ensure the accuracy of the nitrate concentration prediction model and the equivalent concentration offset model. The experimental results demonstrated that by correcting the DOC-induced offsets, the relative error of nitrate prediction was reduced from 94.44% to 3.36%, and the root mean square error of prediction was reduced from 1.6108 mg L−1 to 0.1037 mg L−1, which is a significant correction effect. The proposed method applied to predict nitrate concentrations in samples from two different water sources shows a certain degree of comparability with the standard method. It proves that this method can effectively correct the deviations in nitrate measurements caused by DOC and improve the accuracy of nitrate measurement.
The polarized Monte Carlo (PMC) model has been applied to study the backscattering measurement of oceanic lidar. This study proposes a PMC model for shipborne oceanic lidar simulation. This model is validated by the Rayleigh scattering experiment, lidar equation, and in-situ lidar LOOP (Lidar for Ocean Optics Profiler) returns [ Opt. Express 30, 8927 (2022)10.1364/OE.449554 ]. The relative errors of the simulated Rayleigh scattering results are less than 0.07%. The maximum mean relative error (MRE) of the simulated single scattering scalar signals and lidar equation results is 30.94%. The maximum MRE of simulated total scattering signals and LOOP returns in parallel and cross channels are 33.29% and 22.37%, respectively, and the maximal MRE of the depolarization ratio is 24.13%. The underwater light field of the laser beam is also simulated to illustrate the process of beam energy spreading. These results prove the validity of the model. Further analyses show that the measured signals of shipborne lidar LOOP are primarily from the particle single scatterings. This model is significant for analyzing the signal contributions from multiple scattering and single scattering.
Monte Carlo techniques have been widely applied in polarized light simulation. Based on different preconditions, there are two main types of sampling strategies for scattering direction: one is the scalar sampling method; the others are polarized sampling approaches, including the one- and two-point rejection methods. The polarized simulation of oceanic lidar involves a variety of mediums, and an efficient scattering sampling method is the basis for the coupling simulation of the atmosphere and ocean. To determine the optimal scattering sampling method for oceanic lidar simulation, we developed a polarized Monte Carlo model and simulated Mie scattering, Rayleigh scattering, and Petzold average-particle scattering experiments. This simulation model has been validated by comparison with Ramella-Roman’s program [ Opt. Express 13, 4420 (2005)OPEXFF 1094-4087 10.1364/OPEX.13.004420 ], with differences in reflectance and transmittance Stokes less than 1% in Mie scattering. The simulation results show these scattering sampling methods differ in runtime, scattering angle distributions, and reflectance and transmittance Stokes. Considering the current simulation accuracy of oceanic lidar, the differences in reflectance and transmittance Stokes are acceptable; thus, the runtime becomes the main evaluation factor. The one-point rejection method and scalar sampling method are preferable for the oceanic lidar polarized simulation. Under complex atmosphere-ocean coupling systems, scalar sampling methods may be a better choice since the calculation process of the sampling is independent of the incident Stokes vector.
1 September 2026 in Journal of Oceanology and Limnology