The following article examines the methodology of identifying and modeling kinematic errors of coordinate measuring machines with the use of a modern and precise interferometric system—the LaserTracer. Since the kinematic errors of coordinate measuring machines (CMMs) are by far the most prevalent factor in measurement uncertainty, a specially developed model could be used for efficient uncertainty evaluation as an additional module of the virtual measuring machine responsible for simulation of the CMM kinematic errors. The model could also be of use for determining optimal measurement strategy, and would potentially improve the uncertainty of measurements performed.
Improvements of modern manufacturing techniques implies more efficient production but also new challenges for coordinate metrologists. The crucial task here is a coordinate measurement accuracy assessment. It is important because according to technological requirements, measurements are useful only when they are stated with their accuracy. Currently used methods for the measurements accuracy estimation are difficult to implement and time consuming. It is therefore important to implement correct and validated methods that will also be easy to implement. The method presented in this paper is one of them. It is an on-line accuracy estimation method based on the virtual CMM idea. A model is built using a modern LaserTracer system and a common test sphere and its implementation lasts less than one day. Results obtained using the presented method are comparable to results of commonly used uncertainty estimation methods which proves its correct functioning. Its properties predispose it to be widely used both in laboratory and industrial conditions.
Today many different systems are working in accordance with the idea of coordinate measuring techniques. It is possible to use the same measuring software with optical or contact coordinate systems as well as with a 3D scanners. This gives the opportunity to use different measuring systems for the same tasks. Consequently, it is possible to build faster and more efficient techniques for controlling the production. For example: a fast check of car body production with 3D scanner systems and once per shift accurate measurement of the same element with reference Coordinate Measuring Machines. The main purpose of measurements in industry is the assessment of the conformity or nonconformity of the production with the specification. The specification can be written in classical paper documentation or saved in CAD-file. Never-mind how specification is written or saved, the uncertainty of the measurement should be taken into consideration, according to the ISO 14253-1 guideline. In the case of a supplier – to his benefit, by extending the area of conformity and in the case of production control – by reducing the area of conformity. Evaluation of the coordinate measurement accuracy is very complicated task, especially elaborating of one method for all Coordinate Measuring Systems. Until now, majority of methods focus only on the Coordinate Measuring Machines. ISO 15530 family of standards can be noticed in this area, however, many problems still remain unsolved.
The laser projector based on the laser galvanometer scanning system enables the projection of CAD-based laser images onto geometrical objects. Furthermore, the system can perform a scan of components in order to control proper positioning (e.g., welded structures). We decided to conduct research aimed at determining the suitability of such systems for length measurements and assess their accuracy. These systems are commonly calibrated with the use of flat calibration boards, although their capability of projecting and scanning 3D objects. For this reason, a new method based on ISO 10360 has been proposed. Analysis of the system’s ability to perform length measurements, selection of a reference standard, and the tested device accuracy were the main objectives of the study. A ball-bar with a nominal length of 3000 mm was chosen as a reference standard. Positions of the reference element in the workspace were determined, and three series of five measured deviations were performed in each setting. The obtained values of measurement errors prove that it is possible to use ball-bar standards to assess the accuracy of the described systems, which is defined by the equation MPE(E0) = ±0.5 mm. The proposed method could be adapted to perform more complex analyzes in this area.