During the past two decades, new insights have driven the development and optimization of aminated materials as aldol condensation catalysts. Amines, either primary or secondary, facilitate the reaction via an enamine mechanism. If the spatial placement with respect to the amine allows it, weak acid sites such as silanols or hydroxyls, can cooperate as hydrogen bond donors and aid in proton transfer steps. Furthermore, the reaction environment, i.e., support and solvent and their mutual interactions, is also a key determining factor. In particular, co-feeding small amounts of water suppresses the formation of inhibiting and site-blocking species. However, silica-based materials are susceptible to hydrolysis. This led to the development of water tolerant (bio)polymer supported amine catalysts which also exhibit selective component enrichment properties, opening up opportunities for further catalyst development.
The potential benefits of microwave irradiation for fructose dehydration into 5 hydroxymethylfurfural (5-HMF) have been quantified over a sulfonated metal–organic framework (MOF), MIL 101(Cr)-SO3H. The effects of temperature (140–170 °C), batch time (5–300 min), and catalyst-to-substrate ratio (0.1–0.01 g/g) were systematically mapped. After 10 min of microwave (MW) irradiation at 140 °C in a DMSO–acetone reaction medium, practically complete fructose conversion was obtained with a 70% yield of 5-HMF. Without MW, i.e., using conventional heating (CH) at the same conditions, the fructose conversion was limited to 13% without any 5-HMF yield. Rather, 90 min of CH was required to reach a similarly high conversion and yield. The profound impact of moving from CH towards MW conditions on the reaction kinetics, also denoted as the microwave effect, has been quantified through kinetic modeling via a change in the Gibbs free energy of the transition state. The modeling results revealed an eight-fold rate coefficient enhancement for fructose dehydration owing to MW irradiation, while the temperature dependence of the various reaction steps almost completely disappeared in the investigated range of operating conditions.
The development of a performant aminated catalyst for aldol condensations requires the combined tuning of the active site, support and solvent system. For this purpose, a pyrrolidine group was immobilized on a swellable polymer resin. Favorable interactions between the support and water (in its role as solvent) resulted in a turnover frequency (TOF) amounting to 3.0 ± 1.5 × 10−3 s−1, despite potential inhibition of the active sites by formation of iminium species. The affinity of the solvent for the poly[(ethylene glycol) methacrylate] support resulted in efficient swelling of the catalytic material, which was shown to be key to the observed catalytic performance.