It is known that zinc biodegradable alloys are a promising material for producing biomedical implants for orthopedics and vascular stents. Among them, the Zn-Ag-Cu zinc alloy is of special interest due to the antibacterial and antimicrobial properties of Ag and Cu. To improve the mechanical properties of the Zn-4Ag-1Cu zinc alloy, the effect of equal-channel angular pressing (ECAP) on the microstructure and strength has been investigated. The ECAP conditions for the Zn-4Ag-1Cu alloy were chosen by modeling in the Deform 3 D program (temperature and strain rate). The microstructure was analyzed using transmission electron microscopy, scanning electron microscopy and X-ray diffraction analysis. The study of strength was carried out by measuring the microhardness and tensile tests of small samples with a gauge dimension of 0.8 × 1 × 4 mm3. The microstructure after ECAP was characterized by equiaxed grains ranging in a size from 1.5 µm to 4 µm with particles in a size from 200 nm to 1 µm uniformly distributed along the boundaries. The ECAP samples showed a high strength of 348 MPa and good ductility of up to 30%, demonstrating their great potential as promising materials for producing medical stents.
Grade 91 (9Cr-1Mo) steel was subjected to various heat treatments and then to high-pressure torsion (HPT) at different temperatures. Its microstructure was studied using transmission electron microscopy (TEM) and X-ray diffraction (XRD). Effects of the tempering temperature and the HPT temperature on the microstructural features and microhardness in the ultrafine-grained (UFG) Grade 91 steel were researched. The study of the UFG structure formation takes into account two different microstructures observed: before HPT in both samples containing martensite and in fully ferritic samples.
8 May 2017 in IOP Conference Series: Materials Science and Engineering
Microstructure and strength of commercial martensitic steel processed by equal channel angular pressing (ECAP) has been investigated using transmission electron microscopy and tensile tests. Application of ECAP led to significant grain refinement to a grain size of 0.8 µm and precipitation of particles with a size of 90 nm. Impact of annealing on thermal stability of ultrafine-grained structure was investigated. The contribution of various strengthening mechanisms to strength of steel was discussed.
The influence of the ultrafine-grained (UFG) structure on the fatigue endurance limit and the nature of fatigue failure have been studied. It is shown that the formation of the UFG structure containing carbides and the coincidence site lattice relationship (CSL) and twin boundaries leads to an increase in the fatigue endurance limit. To study the mechanisms of fatigue failure, scanning and transmission electron microscopy and X-ray diffraction analysis were used. Studies have shown that the formation of the UFG structure as a result of rolling and subsequent heat treatment above the temperature of the ferrite/austenite phase transition leads to an increase in the fatigue endurance limit by more than 70%, from 475 to 800 MPa, compared to coarse-grained samples. The dynamic aging observed during fatigue tests was more pronounced in materials with a UFG microstructure. The influence of the CSL and twin boundaries on the nature of the fatigue failure of ferritic–martensitic steel is discussed.
1 November 2019 in IOP Conference Series: Materials Science and Engineering
This paper investigates the strength and specific conductivity of UFG Cu-Fe alloys processed by high-pressure torsion (HPT). The effect of an ultrafine-grained structure and further heat treatment on the increase of microhardness and specific conductivity is examined. The results of the structural study of the UFG samples by electron back-scatter diffraction (EBSD) are presented.