Spent coffee grounds (SCGs) generated in coffee processing for beverages and other products are a very significant organic residue that needs to be properly treated. Waste valorization via oil extraction has the potential to obtain compounds that can be used for producing biodiesel or other high-value products, such as polymers. This work focuses on the ultrasound-assisted extraction of SCG oil using n-hexane as a solvent. Three key process parameters are analyzed: temperature, extraction time, and liquid/solid (L/S) rate of solvent, using a central composite rotatable design (CCRD), an analysis that, to the author’s knowledge, is not yet available in the literature. The data were analyzed using the software StatSoft STATISTICA 13.1 (TIBCO Software Inc., Palo Alto, CA, USA). Results show that all parameters have a statistical influence on the process performance (p < 0.05), being the L/S ratio the most significant, followed by extraction time and temperature. An analysis of variance (ANOVA) showed that the empirical model is a good fit to the experimental data at a 95% confidence level. For the range of conditions considered in this work, the optimal operating conditions for obtaining an oil extraction yield in the range of 12 to 13%wt are a solvent L/S ratio of around 16 mL g−1, for a temperature in the range of 50 to 60 °C, and the longest contact time, limited by the process economics and health and safety issues and also, by the n-hexane boiling temperature.
PFASs are a variety of ecologically persistent compounds of anthropogenic origin loosely included in many industrial products. In these, the carbon chain can be fully (perfluoroalkyl substances) or partially (polyfluoroalkyl substances) fluorinated. Their ubiquitous presence in many environmental compartments over the years and their long-lasting nature have given rise to concerns about the possible adverse effects of PFASs on ecosystems and human health. Among a number of remediation technologies, adsorption has been demonstrated to be a manageable and cost-effective method for the removal of PFASs in aqueous media. This study tested two novel and eco-friendly adsorbents (pinewood and date seeds biochar) on six different PFASs (PFOS, GenX, PFHxA, PFOA, PFDA, and PFTeDA). Batch sorption tests (24 h) were carried out to evaluate the removal efficiency of each PFAS substance in relation to the two biochars. All samples of liquid phase were analyzed by a developed and then a well-established method: (i) pre-treatment (centrifugation and filtration) and (ii) determination by high-performance liquid chromatography coupled with mass spectrometry (HPLC-MS/MS). The results evidenced a comparable adsorption capacity in both materials but greater in the long-chain PFASs. Such findings may lead to a promising path towards the use of waste-origin materials in the PFAS remediation field.
5 February 2021 in Polish Journal of Environmental Studies
The current study seeks to investigate the feasibility use of date palm kernels for the development of activated carbon (AC) towards its application, which functions as an adsorbent to treat oil-contaminated groundwater. Biochar derived from date palm kernels (BPK), was prepared by direct pyrolysis of the raw precursor at 600ºC for 90 minutes (in oxygen-limited condition). Activated carbon (ACPK) included similar pyrolysis conditions of biochar with subsequent impregnation in H2SO4 (as activating agent) at a ratio of acid: biochar (1:1), moderate temperature. The analytical approach was performed through the use of XRD, BET, and FTIR, techniques to evaluate the effect of carbonization and activation process in improving the adsorptive properties of starting materials. Carbonaceous adsorbents obtained were highly porous due to their elevated specific surface area of (333.4 m²/g for BPK and 741.5 m²/g for ACPK) and their amorphous structure. Indeed, the textural proprieties were significantly improved by the acidic treatment. Further, the adsorption behavior of produced materials was tested by performing batch adsorption tests in contaminated water samples using a ratio of 1:1 (g/L) for 24 hours. The efficiency of adsorbents was evaluated by COD (C0 = 8568 mg/L), BOD5 (C0 = 200 mg/L) concentration, pH and hardness values before and after the treatment. Removal efficiency of COD for the BPK and ACPK samples reached 82.6% and 95.2% respectively, while for BOD5 was the same (97.0%) for both adsorbents. Additionally, the treated water sample has the same excellent class suitable for irrigation applications according to the Wilcox diagram. In consequence, the present study suggests an effective, eco-friendly and economical adsorption process intending to mitigate environmental risk sustainably.
This study investigates the efficacy of activated carbons (ACs) derived from Tamarix gallica (TG) leaves for glyphosate removal from aqueous solutions. Two chemical activation methods, using phosphoric acid (H3PO4) and sulfuric acid (H2SO4), were compared to optimize adsorbent performance. The resulting materials, labeled AC-H3PO4 and AC-H2SO4, were comprehensively characterized using XRD, FTIR, SEM-EDS, BET analysis, and pHpzc determination, revealing distinct physicochemical properties. AC-H3PO4 exhibited a larger surface area (580.37 m2/g) and more developed pore structure compared to AC-H2SO4 (241.58 m2/g). Adsorption kinetics were best described by the pseudo-first-order model for both adsorbents. Isothermal studies demonstrated that AC-H3PO4 followed a pore-filling mechanism best described by the Dubinin–Radushkevich model, while AC-H2SO4 showed multilayer adsorption fitting the Freundlich model. Both adsorbents exhibited high glyphosate removal capacities, with maximum Langmuir adsorption capacities of 247.58 mg/g and 235.13 mg/g for AC-H3PO4 and AC-H2SO4, respectively. The mean free energy of adsorption (E) values confirmed physisorption as the dominant mechanism. This research highlights the potential of TG-derived activated carbons as sustainable and effective adsorbents for glyphosate remediation in water treatment applications, demonstrating the impact of activation methods on adsorption performance.
This study explores biochar (BC) derived from date palm seeds as a high-performance adsorbent for the removal of trichloroethylene (TCE) and tetrachloroethylene (PCE) from aqueous solutions, with comparative analysis against commercial activated carbon (AC). The optimized BC, characterized by a high BET surface area of 654.79 m2/g and unique nanotube morphology, demonstrated superior adsorption capacities of 86.68 mg/g for TCE and 85.97 mg/g for PCE, significantly surpassing the AC under identical conditions. Kinetic studies identified the pseudo-second-order model as the best fit, indicating chemisorption as the dominant mechanism. Isotherm modeling revealed a combination of multilayer and monolayer adsorption processes, underscoring the complexity of the BC’s adsorption behavior. Statistical analysis via two-way ANOVA further validated the BC’s significant superiority over the AC (p < 0.0001) for both contaminants. These results highlight the potential of date-palm-seed-derived biochar as a sustainable and cost-effective adsorbent for eco-friendly water treatment, emphasizing its role in reducing environmental impact and operational costs in real-world applications.
5 October 2024 in Environmental Science and Pollution Research