We introduce the fabrication and use of microcracks embedded in glass as an optical element for manipulating light propagation, in particular for enhancing waveguide performance in silica integrated optics. By using a femtosecond laser to induce a strong asymmetric stress pattern in silica, uniform cracks with set dimensions can be created within the substrate and propagated along a fixed path. The smoothness of the resulting cleave interface and large index contrast can be exploited to enhance waveguide modal confinement. As a demonstration, we tackle the longstanding high bend-loss issue in femtosecond laser written silica waveguides by using this technique to cleave the outer edge of laser written waveguide bends, to suppress radiative bend loss. The microcrack cross section is estimated to be 15 μm in height and 30 nm in width, for the 10 $$\times$$× 10 μm waveguides. At 1550 nm wavelength, losses down to 1 dB/cm at 10 mm bend radius were achieved, without introducing additional scattering. Both the cleave stress pattern and waveguide are fabricated with the same multiscan writing procedure, without requiring additional steps, and re-characterisation of the waveguides after 1 year confirm excellent long term performance stability.

We model and experimentally investigate second harmonic generation in silica microfibers and loop resonators, in which the second order nonlinearity arises from the glass-air surface dipole and bulk multipole contributions. In the loop resonator, the recirculation of the pump light on resonance is used to increase the conversion. The effect of the loop parameters, such as coupling and loss, is theoretically studied to determine their influence on the resonance enhancement. Experimentally, microfibers were fabricated with diameters around 0.7 μm to generate the intermodally phase matched second harmonic with an efficiency up to 4.2 × 10⁻⁸ when pumped with 5 ns 1.55 μm pulses with a peak power of 90 W. After reconfiguring the microfiber into a 1 mm diameter loop, the efficiency was resonantly enhanced by 5.7 times.

Most distributed optical fiber sensors rely on commercially available telecom fibers, which are low-loss, inexpensive, and standardized. In the last few years, significant effort has been made to develop optical fibers optimized for specific sensing applications, with the view of improving the signal-to-noise ratio (SNR) or extending the distance over which distributed optical fiber sensors (DOFS) operate. This tutorial reviews the efforts made by the scientific community towards the development of enhanced backscattering fibers and enhanced backreflection fibers, with a focus on DOFS.

We investigate the interaction between fundamental and third harmonic fields in a nonlinear waveguide. We develop a method for evaluating the maximum efficiency of third harmonic (upconversion) and one-third harmonic (downconversion) generation by considering the solitonic behavior of the interaction. This method can be used to engineer waveguide parameters and identify the input power that enables maximum conversion efficiency to be achieved.

An ultrasensitive optical nanofiber coupler (NFC) for thermal and refractive index sensing with nanoscale dimension is proposed and experimentally demonstrated. The NFC operating near the cut-off region of the higher order modes is fabricated by fusing and pulling two standard telecom fibers using the modified flame brushing technique. Due to the submicron diameter, the NFC exhibits an anomalous behavior in close proximity to the odd supermode cut-off wavelength, where the high extinction ratio spectral oscillations exhibit very slow oscillations. The sensitivity of this region is exploited for thermal sensing over a broad range of temperatures (84 °C-661 °C). An average temperature sensitivity of 55 pm/°C and a maximum sensitivity of 60 pm/°C at the highest temperature were demonstrated. Owing to its small size, the thermal sensor exhibits a fast response time of ~7.2 ms. The sensor capability for detecting refractive index changes is also examined with different ethanol concentrations. A record sensitivity of 4.80 × 10 ⁵ nm/RIU was achieved, which is the highest reported value in all optical fiber refractometers.

We simulate and experimentally demonstrate deep ultraviolet generation from a 1550 nm laser source in a fully fiberized system by cascading second- and third-harmonic generation using a periodically poled silica fiber and an optical sub-micron diameter fiber. Harmonic generation is achieved by harnessing intermodal phase matching in optical microfibers and a permanent ${\chi }^{(2)}$ induced via thermal poling. As a result, efficient nonlinear processes can be observed, despite the low third-order nonlinear susceptibility of silica glass.