Increasing the average power of broadband, few-cycle terahertz (THz) sources is currently a topic of intense investigation, fueled by recent immense progress in high average power femtosecond laser driving sources at 1030 nm. However, many crucial applications would benefit not only from an increase in average power, but also from ultra-broad bandwidth, while maintaining high dynamic range at these frequencies. This calls for the challenging combination of high repetition rates and high average power simultaneously. Here, we discuss the recent progress in the promising approach enabled by organic crystals for THz-generation. Specifically, this review article discusses advances with the most commonly used organic crystals BNA, DAST, DSTMS, OH1 and HMQ-TMS. We place special emphasis on nonlinear and thermal properties and discuss future directions for this field.
We demonstrate efficient optical rectification in the organic crystal BNA (N-benzyl-2-methyl-4-nitroaniline), driven by a temporally compressed, commercially available industrial Yb-laser system operating at a 540 kHz repetition rate. Our terahertz (THz) source reaches 5.6 mW of THz average power driven by 4.7 W, 45 fs pulses, and the resulting THz-time domain spectroscopy combines a very broad bandwidth of 7.5 THz and a high dynamic range of 75 dB (in a measurement time of 70 s). The conversion efficiency at maximum THz power is 0.12%. To the best of our knowledge, this is the highest THz power so far demonstrated with BNA, achieved at a high repetition rate and enabling to demonstrate a unique combination of bandwidth and dynamic range for THz-spectroscopy applications.
Multi-pass cell (MPC) based temporal pulse compressors have emerged in recent years as a powerful and versatile solution to the intrinsic issue of long pulses from Yb-based high-power ultrafast lasers. The spectral broadening of high-energy (typically more than 100 µJ) pulses has only been realized in gas-filled MPCs due to the significantly lower nonlinear coefficient of gases compared with solid-state media. Whereas these systems reach impressive performance in terms of spectral broadening with very low spatiotemporal couplings, they are typically complex setups, i.e., large and costly pressure-controlled vacuum chambers to avoid strong focusing, ionization, and damage to the mirrors. Here, we present spectral broadening of 2-mJ pulses in a simple and compact (60-cm-long) multi-pass cell operated in ambient air. Instead of the traditional Herriott cell with concave-concave (CC/CC) mirrors, we use a convex–concave (CX/CC) design, where the beam stays large at all times, both minimizing damage and allowing operation in ambient air. We demonstrate spectral broadening of 2.1-mJ pulses at 100 kHz repetition rate (200 W of average power) from 2.1 nm (pulse duration of 670 fs) to a spectral bandwidth of 24.5 nm, supporting 133-fs pulses with 96% transmission efficiency. We show the compressibility of these pulses down to 134 fs and verify that the spectral homogeneity of the beam is similar to previously reported CC/CC designs. To the best of the authors’ knowledge, this is the first report of a CX/CC MPC compressor operated at high pulse energies in air. Because of its simplicity, small footprint, and low cost, we believe this demonstration will have significant impact in the ultrafast laser community.
Multi-pass cell (MPC) compressors have proven to be the method of choice for compression of high average power long-pulse Yb lasers. Yet, generating sub-30 fs pulses at high pulse energy with compact and simple components remains a challenge. This work demonstrates an efficient and cost-effective approach for nonlinear pulse compression at high pulse energy using a hybrid air-bulk MPC. By carefully balancing the relative nonlinear contributions of ambient air and fused silica, we achieve strong spectral broadening without dispersion engineering or pressure-control inside the cell at 400-µJ pulse energy. In this way, we compress pulses from 220 fs to 27 fs at 40.3 W of average power (100 kHz repetition rate), enhancing the peak power from 1.6 GW to 10.2 GW while maintaining 78% of the energy within the main pulse. Our approach combines the strengths of gas-filled and bulk compression schemes and exhibits excellent overall optical transmission (91%) and spectral uniformity. Moreover, we utilize the INSIGHT technique to investigate spatio-temporal couplings and geometrical aberrations of the compressed pulse. Our results demonstrate remarkable temporal homogeneity, with an average Strehl ratio of 0.97 consistently observed throughout the entire spectral profile. Additionally, all spectrally-integrated Zernike coefficients for geometrical aberrations maintain values below 0.02λ.
High-power ultrafast laser sources in the short-wave infrared region are of great interest for numerous applications, including secondary sources of radiation and processing of materials commonly opaque in the near-infrared region. In this wavelength region, direct laser amplification around 2.1 µm wavelength within the atmospheric transparency window is particularly attractive for realizing compact and efficient high-power lasers. However, this wavelength region was widely underrepresented in femtosecond laser technology so far. Here, we report on a 2.1 µm laser system delivering 97 fs pulses with an unprecedented combination of high peak power of 525 MW and high repetition rate of 100 kHz. The amplifier system consists of a mode-locked oscillator seeding a regenerative amplifier (RA) using the broadband material holmium (Ho)-doped CaAlGdO4 (CALGO), operating in the chirped pulse amplification (CPA) scheme and a nonlinear compression stage based on a Herriott-type multi-pass cell (MPC) with bulk material. We demonstrate the potential of this laser system by generating a microplasma in ambient air, demonstrating its high intensity for future plasma-driven secondary sources. This system bridges the gap between conventional 1-to-10 kHz amplifiers and high-power MHz laser oscillators in this attractive wavelength range.
The advent of high-average-power, ultrafast ytterbium-based lasers allows us to generate laser filaments at repetition rates ranging from tens of kHz up to hundreds of kHz. At such high-repetition rates, the inter-pulse time lies below the time required for the total diffusion of the deposited heat by each laser pulse, leading to cumulative hydrodynamic effects. Here, we present experimental time-resolved measurements of these dynamics in air for laser repetition rates between 1 and 100 kHz. We measure the change in the air refractive index caused by the localized heat deposition and the length of the filament-generated plasma channel, with which we can infer the corresponding change in air density. We observe that at repetition rates above 10 kHz, stationary density depletions with vanishing dynamics emerge. Our findings are of wide relevance for the fields of high-repetition-rate laser filamentation and its applications as well as THz generation from laser-induced plasma sources.