We demonstrate terahertz (THz) generation using the tilted pulse front method in lithium niobate, driven at an unprecedented high average power of more than 100 W and at a 13.3 MHz repetition rate, provided by a compact amplifier-free mode-locked thin-disk oscillator. The conversion efficiency was optimized with respect to the pump spot size and pump pulse duration, enabling us to generate a maximum THz average power of 66 mW, which is, to the best of our knowledge, the highest reported to date from a laser-driven, few-cycle THz source. Furthermore, we identify beam walk-off as the main obstacle that currently limits the conversion efficiency in this excitation regime (with moderate pulse energies and small spot sizes). Further upscaling to the watt level and beyond is within reach, paving the way for linear and nonlinear high average power THz spectroscopy experiments with an exceptional signal-to-noise ratio at megahertz repetition rates.
We demonstrate a high repetition-rate, single-cycle THz source with a maximum average power of 1.35 mW, operating at a center frequency of 2 THz. This result was obtained by optical rectification (OR) in GaP using an amplifier-free, nonlinearly compressed modelocked thin-disk oscillator based on Yb:YAG, delivering 8.4 µJ pulses with 88 fs duration at a repetition rate of 13.4 MHz, resulting in driving pulses for OR with 112 W average power and 80 MW peak power. To the best of our knowledge, our result represents the highest average power so far achieved with OR in GaP. The demonstrated performance is very attractive for improving current linear THz time-domain spectroscopy experiments, which are currently restricted by low signal-to-noise ratio and long measurement times.
Increasing the average power of broadband, few-cycle terahertz (THz) sources is currently a topic of intense investigation, fueled by recent immense progress in high average power femtosecond laser driving sources at 1030 nm. However, many crucial applications would benefit not only from an increase in average power, but also from ultra-broad bandwidth, while maintaining high dynamic range at these frequencies. This calls for the challenging combination of high repetition rates and high average power simultaneously. Here, we discuss the recent progress in the promising approach enabled by organic crystals for THz-generation. Specifically, this review article discusses advances with the most commonly used organic crystals BNA, DAST, DSTMS, OH1 and HMQ-TMS. We place special emphasis on nonlinear and thermal properties and discuss future directions for this field.
Metallic spintronic terahertz (THz) emitters have become well-established for offering ultra-broadband, gapless THz emission in a variety of excitation regimes, in combination with reliable fabrication and excellent scalability. However, so far, their potential for high-average-power excitation to reach strong THz fields at high repetition rates has not been thoroughly investigated. In this article, we explore the power scaling behavior of tri-layer spintronic emitters using an Yb-fiber excitation source, delivering an average power of 18.5 W (7 W incident on the emitter after chopping) at 400 kHz repetition rate, temporally compressed to a pulse duration of 27 fs. We confirm that a reflection geometry with back-side cooling is ideally suited for these emitters in the high-average-power excitation regime. In order to understand limiting mechanisms, we disentangle the effects on THz power generation by average power and pulse energy by varying the repetition rate of the laser. Our results show that the conversion efficiency is predominantly determined by the incident fluence in this high-average-power, high-repetition-rate excitation regime if the emitters are efficiently cooled. Using these findings, we optimize the conversion efficiency and reach highest excitation powers in the back-cooled reflection geometry. Our findings provide guidelines for scaling the power of THz radiation emitted by spintronic emitters to the milliwatt-level by using state-of-the-art femtosecond sources with multi-hundred-Watt average power to reach ultra-broadband, strong-field THz sources with high repetition rate.
We demonstrate efficient optical rectification in the organic crystal BNA (N-benzyl-2-methyl-4-nitroaniline), driven by a temporally compressed, commercially available industrial Yb-laser system operating at a 540 kHz repetition rate. Our terahertz (THz) source reaches 5.6 mW of THz average power driven by 4.7 W, 45 fs pulses, and the resulting THz-time domain spectroscopy combines a very broad bandwidth of 7.5 THz and a high dynamic range of 75 dB (in a measurement time of 70 s). The conversion efficiency at maximum THz power is 0.12%. To the best of our knowledge, this is the highest THz power so far demonstrated with BNA, achieved at a high repetition rate and enabling to demonstrate a unique combination of bandwidth and dynamic range for THz-spectroscopy applications.
We demonstrate a 13.3 MHz repetition rate, broadband THz source with milliwatt- average power, obtained by collinear optical rectification of a high-power Yb-doped thin-disk laser in the organic crystal BNA (N-benzyl-2-methyl-4-nitroaniline). Our source reaches a maximum THz average power of 0.95 mW with an optical-to-THz efficiency of 4×10−4 and a spectral bandwidth spanning up to 6 THz at -50 dB, driven by 2.4 W average power (after an optical chopper with duty cycle of 10%), 85 fs-pulses. This high average power excitation was possible without damaging the crystal by using a diamond-heatsinked crystal with significantly improved thermal properties. To the best of our knowledge, this result represents the highest THz average power reported so far using the commercially available organic crystal BNA, showing the potential of these crystals for high average power, high repetition rate femtosecond excitation. The combination of high power, high dynamic range, high repetition rate and broadband spectrum makes the demonstrated THz source highly attractive to improve various time-domain spectroscopy applications. Furthermore, we present a first exploration of the thermal behavior of BNA in this excitation regime, showing that thermal effects are the main limitation in average power scaling in these crystals.