Design and Maintenance of Gas pipelines, Ivano-Frankivsk National Technical University of Oil and Gas, Ivano-Frankivsk, Ivano-Frankivs’ka Oblast’, Ukraine
Dr. Mykola Iakymiv
Design and Maintenance of Gas pipelines, Ivano-Frankivsk National Technical University of Oil and Gas, Ivano-Frankivsk, Ivano-Frankivs’ka Oblast’, Ukraine
The aim of the article is the development of methods for optimal overhaul planning of compressor station equipment. Nowadays, due to uncertainties in the forecast of gas supply flow rates, increasing the reliability and energy efficiency of main gas pipelines is an urgent problem. The dependence of operating costs for major repairs on the maintenance periodicity is extreme. Reducing equipment’s maintenance period leads to an increase in repair costs. It also increases the reliability of equipment operation. Overall, all these facts reduce the probability of emergency failures and related expenses for emergency recovery, gas losses, and undersupply to consumers. Therefore, an optimal maintenance frequency exists, at which the total operating costs will be minimal. A procedure for optimizing the periodicity of repairs and equipment replacement is proposed. It was realized by constructing an objective function as a dependence of exploitation costs on the inter-repair period of major repairs. A probabilistic approach was applied to assess the aging process. The characteristics of the equipment’s state are described by distribution densities (i.e., pre-repair, inter-repair, and full-service life), which vary depending on product initialization time. The main characteristics of major repairs are their duration and intensity, which are evaluated by the quality factor related to repair costs. The extremum of the objective function is sought by the method of competing options. It was determined that the optimal management of the frequency of equipment replacement can be realized by choosing the optimal values of the average service life, average operation time of units until the first planned and preventive repair, and quality factor. As a result, the required technical condition for the technological equipment is ensured under minimum operating costs without reducing the system’s reliability.
Prolonged operation of the gas-transport system in conditions of partial loading involves frequent changes in the volume of gas transportation, which necessitates prompt forecasting of system operation. When forecasting the modes of operation of the gas transport system, the main criterion of optimality implies the maximum volume of gas pumping. After all, in this case, the largest profit of the gas-transport company is achieved under the condition of full provision of consumers with energy. In conditions of incomplete loading of the gas-transport system caused by a shortage of gas supply, optimality criteria change significantly. First, the equipment is operated in ranges far from nominal ones which leads to growth of energy consumption. Secondly, changes in performance cause high-amplitude pressure fluctuations at the outlet of compressor stations. Based on mathematical modeling of nonstationary processes, amplitude and frequency of pressure fluctuations at the outlet of compressor stations which can cause the pipeline overload have been established. To prevent this, it was proposed to reduce initial pressure relative to the maximum one. Calculated dependence was obtained which connects the amplitude of pressure fluctuations with the characteristics of the gas pipeline and the nonstationary process. Reduction in energy consumption for transportation is due to the shutdown of individual compressor stations (CS). Mathematical modeling has made it possible to establish regularities of reduction of productivity of the gas-transport system and duration of the nonstationary process depending on the location of the compressor station on the route. With an increase in the number of shutdown compression stations, the degree of productivity decrease and duration of nonstationarity reduces The established patterns and proposed solutions will improve the reliability of a gas-transport system by preventing pipeline overload and reduce the cost of gas transportation by selecting running numbers of shutdown stations with a known decrease in productivity.