The effectiveness of herbicides is affected by the pH of the spray liquid. The use of adjuvants can mitigate the negative effect of pH, and it also allows for a reduction in herbicide doses while maintaining high efficiency. Greenhouse studies were performed to evaluate the efficacy of the herbicide sulcotrione (HRAC F2), against barnyardgrass, at full or reduced doses with adjuvants, and a modified pH of the solutions. The contact angle and surface tension of liquid spray drops, as well as the shear viscosity of individual solutions, were also tested. Results indicated that at a low pH of the spray liquid (4), the use of a reduced dose of sulcotrione with adjuvant based on methylated rapeseed oil can increase the effectiveness of barnyardgrass control to the same level as at the full dose of herbicide. The use of adjuvants contributed to the reduction in the contact angle and the surface tension of liquid spray droplets. No significant differences in shear viscosity were observed for individual solutions.

The article is focused on the comprehensive analysis of the aerodynamics of air distribution devices with the combined heat and mass exchange, with the aim to improve the following hydro- and thermodynamic parameters of ventilation systems: flow rate, air velocity, hydraulic losses, and temperature. The inadequacy of the previously obtained characteristics has confirmed the need for more rational designs of air distribution systems. Consequently, the use of perforated plates was proposed to increase hydraulic losses for reducing the average velocity and ensuring a uniform distribution of the velocity field on the outlet of the device. The effectiveness of one of the five possible designs usage is confirmed by the results of numerical simulation. The coefficient of hydraulic losses decreased by 2.5–3.0 times, as well as the uniformity of the outlet velocity field for the air flow being provided. Based on the three-factor factorial experiment, the linear mathematical model was obtained for determining the dependence of the average velocity on the flow rate, plate’s area, and diameter of holes. This model was significantly improved using the multiparameter quasi-linear regression analysis. As a result, the nonlinear mathematical models were obtained, allowing the analytical determination of the hydraulic losses and average velocity of the air flow. Additionally, the dependencies for determining the relative error of measuring the average velocity were obtained.