Observing the vertical diffusion distribution of methane fugitive emissions from oil/gas facilities is significant for predicting the pollutant’s spatiotemporal transport and quantifying the random emission sources. A method is proposed for methane’s vertical distribution mapping by combining the laser path-integral sensing in non-non-cooperative open paths and the computer-assisted tomography (CAT) techniques. It uses a vertical-plume-mapping optical path configuration and adapts the developed dynamic relaxation and simultaneous algebraic reconstruction technique (DR-SART) into methane-emission-distribution reconstruction. A self-made miniaturized TDLAS telemetry sensor provides a reliable path to integral concentration information in non-non-cooperative open paths, with Allan variance analysis yielding a 3.59 ppm·m sensitivity. We employed a six-indexes system for the reconstruction performance analysis of four potential optical path-projection configurations and conducted the corresponding validation experiment. The results have shown that that of multiple fan-beams combined with parallel-beam modes (MFPM) is better than the other optical path-projection configurations, and its reconstruction similarity coefficient (ε) is at least 22.4% higher. For the different methane gas bag-layout schemes, the reconstruction errors of maximum concentration (γm) are consistently around 0.05, with the positional errors of maximum concentration (δ) falling within the range of 0.01 to 0.025. Moreover, considering the trade-off between scanning duration and reconstruction accuracy, it is recommended to appropriately extend the sensor measurement time on a single optical path to mitigate the impact of mechanical vibrations induced by scanning motion.
Heating furnaces fueled by fossil fuels are commonly utilized in oilfields to provide heat to the settling tank, which heats the layer of crude oil. However, this traditional heating method consumes a significant amount of oil and gas resources, resulting in low energy utilization and environmental pollution. As the water content of the extracted crude oil increases over time, the operating costs of the settling tanks also continue to increase. Therefore, it is crucial to develop and implement clean and efficient heating technologies to facilitate the efficient operation of settling tanks. This paper proposes a solar–gas combined heating technology for settling tanks. A simulation model for the solar–gas combined heating system for the settling tank is constructed, considering the overall perspective of the system. The simulation model analyzes the impact of the control strategy for the oil collection period of the settling tank on the system performance. This analysis covers various aspects including the heat collection of the solar collector, the heat supply of the gas boiler, and the heat storage and release of the phase-change heat storage tank. The results demonstrate that when the oil collection cycle is Scheme E (4:00–8:00), the collector achieves the highest annual cumulative heat collection, the gas boiler provides the lowest annual total heat supply, and the phase-change heat storage tank exhibits the highest heat storage and release efficiency. Over the course of the system’s 15 year service life, the settling tank solar–gas combined heating system saves 727,988.69 MJ of energy annually, resulting in total energy-saving costs of CNY 397,007. The dynamic investment payback period is estimated at 9.14 years, and the system reduces CO2 emissions by 753,069.8 kg.
The base of solar collector systems is usually installed in soil that contains moisture. In cold regions, due to the low ambient temperature, the moisture in the soil freezes, creating a risk of frost heave. This study analyzed the frost heave mechanism of power transmission and transformation foundation, clarified the factors affecting soil frost heave and the way to solve soil layer frost heave, and proposed the use of heat transfer elements to pre-frozen soil layers to prevent the foundation of the solar collector system from freezing. A numerical model of the ground heat exchange pipes in soil was established. The effects of different soil types, soil moisture content, and the effective radius and operating time on the heat transfer performance of the system were investigated by the verified numerical model. The results show that the heat pipe pre-freezing technology can reduce the drop in soil temperature, thereby increasing the temperature difference between the ground heat exchange pipe and the far-field soil. In terms of the ability to delay the decline in soil temperature, reducing the water content and selecting certain clays can increase the degree and speed of the drop in soil temperature.