In this paper, a new topology of a Fractional Order PID (FOPID) controller is proposed to control a boost DC-DC converter with minimum over/undershoot. The fractional controller parameters are tuned using a genetic algorithm (GA) with a combined cost function composed of the Integral of Time-Weighted Absolute Error (ITAE) and the Integral of Time-Weighted Square Error (ITSE). Despite adding moderate complexity to the control structure, the simulation results reveal that the GA-based FOPID controller tuning provided better performance for the setpoint tracking both under load variations and parameters deviation due to the prolonged use. The proposed FOPID shows a wide operational range concerning load disturbances, and capacitance/inductance deviations of $\pm 30$% and $\pm 50$% from nominal values, achieving functionality and voltage stability even with output power 50% higher than the converter power specification. The assessment was made considering operation in voltage mode and the performance was compared to conventional Proportional-Integral (PI), Type II and current mode controllers. Finally, a fuzzy fractional-order PID (FFOPID) was designed to outperform the FOPID during disturbances in the control variable.

This paper proposes a generalized predictive control (GPC) with constraints and orthonormal Laguerre functions using the simplified model of the primary system (reactor core and intermediate heat exchanger (IHX)) of a prototypical sodium fast reactor (SFR). This paper develops a multiple-input multiple-output (MIMO) GPC with input constraints able to track polynomial references of any degree applied in coolant temperature difference across the core and fractional power. The manipulated variables of the GPC-SFR are the reactivity and the sodium flow rate of the primary and secondary pipes. Moreover, orthonormal Laguerre functions and step down condition number techniques were also applied to avoid the numerical ill-conditioning issue in quadratic programming of large systems. Thus, a GPC type-2 was designed to control fractional power, coolant temperature difference across the core and sodium tank temperature of the SFR primary system when temperature references change according to a linear ramp after reaching their steady-state operation, sustaining 100% power operation on the reactor. In order to analyze the load tracking capability of the GPC-SFR type-2, the load following from 100% fractional power (FP) to 60% FP at 0.8% FP/min rate is simulated. Constraints on the rate of coolant temperature difference across the core and reactivity were applied for the design safety. For comparison criteria, this paper compares the GPC-SFR type-2 with the GPC-SFR type-1, i.e, standard model predictive control (MPC), to verify the viability and superior performance of the proposal regarding: (a) ramp-tracking capability of temperature and load; (b) the rejections of a reactivity disturbance of -1 cent and a secondary sodium inlet temperature disturbance of +10°F; and (c) a simulation with uncertainty in reactor design. The simulations show that the GPC-SFR type-2 overcome the GPC-SFR type-1 robustness and performance.

This work proposes a design methodology for predictive control applied to the single-phase PWM inverter with an LC filter. In the design, we considered that the PWM inverter has parametric uncertainties in the filter inductance and output load resistance. The control system purpose is to track a sinusoidal signal at the inverter output. The designed control system with an embedded integrator uses the principle of receding horizon control, which underpinned predictive control. The methodology was described by linear matrix inequalities, which can be solved efficiently using convex programming techniques, and the optimal solution is obtained. MATLAB-Simulink and real-time FPGA-in-the-loop simulations illustrate the viability of the proposed control system. The LMI-based MPC reveals an effective performance for tracking of a sinusoidal reference signal and disturbance rejection of input voltage and load perturbations for the inverter subject to uncertainties.