The intermetallic transition metal B2‐structured aluminide RuAl is a candidate material for use in various applications, including microelectronics and structural materials under demanding conditions, for example, as oxidation‐ and corrosion‐resistant materials. In contrast to other B2 transition metal aluminides, which usually suffer from brittle material behavior at room temperature, RuAl exhibits comparatively good room‐temperature ductility, in combination with further promising properties. Therefore, RuAl thin films are attracting interest as potential protective and functional surface engineering materials. The synthesis of RuAl thin films by physical vapor deposition, especially magnetron sputtering, is however complex and utilizes codeposition and multilayer from elemental sputtering targets and subsequent annealing procedures. Herein, an alternative route toward single‐phase B2‐structured RuAl thin films by nonreactive DC magnetron sputter deposition at low substrate temperature from a powdermetallurgically manufactured Ru50Al50 compound target is described. The influence of the deposition parameters on the constitution, microstructure, and selected properties of RuAl thin films is studied. It is shown that especially the Ar process gas pressure has a significant impact on their composition and morphology. X‐ray diffraction and transmission electron microscopy with selected‐area electron diffraction indicate that the films are single‐phase RuAl with B2 structure.
In this study, we report on phase formation and microstructure evolution in multiscale magnetron sputtered Ru/Al multilayers upon thermal annealing in vacuum at slow heating rates of 10 K/min. By specifically adjusting the microstructure and design of the as-deposited multilayers, the formation of certain desired phases can be tuned. We demonstrate that the synthesis of single phase RuAl thin films is possible in a very controlled manner in a solid state only via thermal activation without initiating the self-propagating exothermic reactions of Ru/Al multilayers. To investigate phase formation sequences and the resulting microstructures, Ru/Al multilayers were designed via magnetron sputtering with systematic variation of bilayer modulation periods and subsequent vacuum annealing. Thin films samples were characterized by in situ high-temperature XRD, TEM imaging and diffraction. It is shown that different phase sequences appear in strong correlation with the modulation length. Depending on the multilayer design, the phase formation toward single-phase RuAl thin films happens as either a multi-step or single-step event. In particular, below a critical threshold of the modulation period, the multi-step phase formation can be suppressed, and only the desired RuAl target phase is obtained with a pronounced growth in a preferred orientation. This finding may be versatile for the targeted synthesis of intermetallic phases, contributing to further understanding of phase formation in such nanoscale multilayer systems.
12 June 2023 in Journal of Vacuum Science & Technology A
The self-propagating reaction in binary Al/Ru multilayers with two different bilayer thicknesses (89 and 178 nm, respectively) forming single-phase AlRu intermetallic compound is investigated experimentally and by means of phase-field simulations. Experimentally, the time-temperature evolution in free-standing films was recorded with a high-speed pyrometer, and the resulting microstructure was determined from electron backscatter diffraction measurements. The phase-field model is constructed based on the minimization of the grand potentials for which the required thermodynamic data are taken from the Calphad database. The simulation of the reaction and subsequent AlRu grain growth starts from Al-rich and Ru-rich layer fillings. After the formation of the AlRu phase is complete, the grain growth during cooling is simulated based on the experimentally recorded time-temperature curves. Finally, the resulting grain sizes obtained from the simulation are found to be in good agreement with the experimental results. Furthermore, it is shown that the final grain sizes in both simulations and experiments depend on the initial bilayer thicknesses.