Body-centered cubic (BCC) Mg–Li alloy can be effectively strengthened by with the addition of Al and Zn. However, adding excessive amounts result in reduced mechanical properties and damping capacity of the alloy during subsequent heat treatment and deformation. The effects of solution-hot rolling-aging on the mechanical properties and damping capacity of LAZ1333 alloy and LAZ1366 alloy were studied. The solid solution strengthening greatly increases the hardness of the alloy, but the ductility is extremely poor. The AlLi softening phase precipitated during the subsequent hot rolling and aging process greatly improves the ductility of the alloy, but the excess precipitation of in the AlLi softening phase and the solid solution of excess Zn element are not conducive to the substantial improvement of the strength and ductility of the alloy. Excessive addition of alloying elements is detrimental to the damping capacity of the alloy, but the damping capacity of the alloy can be significantly improved by depleting the number of solute atoms through subsequent ageing treatments. The UTS and FE of as-cast LAZ 1333 alloy are 111 MPa and 16.9%, respectively. The as-aged LAZ1333 alloy has the best mechanical properties and damping capacity, and the UTS and FE are increased by 65.8% and 89.3%, respectively, compared to the as-cast alloy, and the damping capacity increased from 0.011 to 0.015.
23 January 2024 in ACS Applied Electronic Materials
Cu-Ni-Si is a prominent example of a high-end lead frame copper alloy. The enhancement of strength without compromising electrical conductivity has emerged as a prominent research focus. The evolution of the precipitates exerts a significant influence on the strength and electrical conductivity of Cu-Ni-Si-Co-Mg alloys. In this paper, the effects of aging treatment and Mg addition on the properties and precipitates of cold-rolled Cu-Ni-Si-Co alloys were studied. The precipitate was (Ni, Co)2Si and was in a strip shape. During aging, precipitation and coarsening of the (Ni, Co)2Si precipitates were observed. In the early stage of aging, a significant number of fine (Ni, Co)2Si precipitates were formed. These fine precipitates could not only have a better effect of precipitation strengthening, but also impeded the dislocation movement, thus increasing the dislocation density and improving the dislocation strengthening effect. However, the coarsening of the precipitates became dominant with increasing aging times. Therefore, the strengthening effect was weakened. The addition of 0.12% Mg promoted finer and more diffuse precipitates, which not only improving the tensile strength by 100–200 MPa, but also exhibiting a smaller effect on the electrical conductivity. However, further increases in Mg contents resulted in a significant decrease in electrical conductivity, with little change in the tensile strength. The optimum amount of added Mg was 0.12%, and the aging parameters were 300 °C and 20 min.
5 May 2025 in Journal of Materials Science: Materials in Electronics