As the use of inductor-based topologies demands a large amount of space, capacitor-based topologies have garnered attention. Electric Vehicles (EVs) are usually equipped with two-level inverters, which require separate control strategies for each level and synchronizing the strategies increases the complexity of operation and makes them unreliable. Therefore, a single-stage converter with boost and conversion abilities with better power quality at optimal component count and efficiency is needed. A novel capacitor-based boost multilevel inverter (CB-MLI) topology is proposed in this paper as it is found suitable for EV and HEV applications. It is capable of generating an eleven-level waveform with only eleven switches, three capacitors, and a single isolated source. The self-balancing property of the capacitors makes the topology one of a kind. A constant carrier PWM-based control strategy is utilized to switch the IGBTs. Testing results from hardware setup confirm the proposed capacitor-based CB-MLI topology operating modes and potentiality. Lastly, by highlighting the proposed and existing MLI circuits, the benefits of the recommended configuration are outlined by component count and total cost. Additionally, it is a simplified design that needs fewer footprint areas and space.
This letter proposes a novel quadruple boost nine-level inverter (QB-NLI) and an optimized switching pattern using fuzzy logic controller. The suggested method simplifies the traditional approach by removing the conventional logic gate circuit design. The pulse signal generator and lookup table are both derived using a fuzzy logic pulse generator. Fuzzy logic controller (FLC) and Controlled membership functions (MFs) rules open numerous prospects for generating pulses based on the input as modulation index. The suggested technique is examined on the proposed QB-NLI topology using the selective harmonic elimination PWM method. MFs are created based on averaging Newton Rapson and quantizer firing angles for diverse modulation index (mi) values. The proposed QB-NLI structure comprises ten switches with one dc-voltage source and two capacitors. The proposed structure’s circuit description, modes of operation, proper component selection, and a new fuzzy-based switching scheme are presented. Further, a discussion about the comparative analysis of the proposed switching technique with other switching techniques concerning THD and RMS voltages is presented. In addition to the simulation results, experimental tests are conducted under various load conditions on the built-in hardware prototype to evaluate the proposed QB-NLI structure and switching technique.
31 March 2023 in International Journal of Circuit Theory and Applications