Boundary layer pumps, although attractive due to their compactness, robustness and multi-fluid and phase-handling capability, have been reported to have low experimental efficiencies despite optimistic predictions from analytical models. A lower-order flow-physics-based analytical model that can be used as a 1D design code for sizing and predicting pump performance is described. The rotor component is modelled by means of the Navier–Stokes equations as simplified using velocity profiles in the inter-disk gap, while the volute is modelled using kinetic-energy-based coefficients inspired by centrifugal pumps. The code can predict the rotor outlet and overall pump pressure ratio with an around 3% and 10% average error, respectively, compared to the reference experimental data for a water pump. Moreover, 3D RANS flow-field explorations of the rotor are carried out for different inter-disk gaps to provide insights concerning the improvement of the 1D design code for the better prediction of the overall pump performance. Improvements in volute loss modelling through the inclusion of realistic flow properties at the rotor outlet rather than the detailed resolution of the velocity profiles within the rotor are suggested as guidelines for improved predictions. Such improved design codes could close the gap between predictions and experimental values, thereby paving the way for the appropriate sizing of boundary layer pumps for several applications, including aircraft thermal management.
24 September 2025 in Journal of Engineering for Gas Turbines and Power
Several researchers in literature have claimed that boundary layer pumps have an increased resistance to cavitation because of the absence of blades. Their conclusion was obtained analytically by applying the simple assumption of uniform radial velocity at the entrance of all the channels. This study considers the effect of flow distribution between the channels and assesses the full 3D geometry of a boundary layer pump which was tested in an experimental campaign by Morris. The pump's flow field is obtained with steady-state multiphase 3D-RANS simulations in which the inlet total pressure is gradually reduced. For each inlet total pressure point, the vapor formation is examined, and hence the cavitation mechanisms are analyzed, and the head drop curve is obtained. Results show that the mass flow distribution in the channels is highly nonuniform, which heavily affects vapor formation areas. There is a 127% difference between the lowest and highest channel mass flow. Less mass flow is entering the channels closer to the entrance of the pump, because this requires the flow to turn almost 90 deg from the axial to the radial direction. The viscous forces accelerate less mass more easily, and this leads to up to 22% lower pressure values in the low flow channels. Therefore, vapor starts forming in these channels, and the further the net positive suction head (NPSH) reduces, it sequentially propagates to adjacent channels toward the back like a domino and expands its volume inside each gap.