We report a micro light-emitting diode ( $\mu $ LED) pixel circuit using low-temperature poly-Si oxide (LTPO) thin film transistors (TFTs). The pixel circuit operates by pulse width modulation (PWM) to prevent the wavelength shift of $\mu $ LED. The proposed PWM can support 10-bit gray scale at a refresh rate of 120 Hz by PWM, thanks to the fast rise and fall times. Note that the circuit also compensates for the variation of the threshold voltage ( $\text{V}_{\text {TH}}{)}$ of the TFTs in the pixel. It is found that the current error rate is 3.7%, and the maximum pulse width error rate is 3.4% for low gray levels when the $\text{V}_{\text {TH}}$ shift is 0.5 V. The fabricated pixel circuit successfully demonstrates PWM of variable gray levels, with measured rise and fall times of $3~\mu \text{s}$ and $0.3~\mu \text{s}$ , respectively. Therefore, the proposed pixel circuit is suitable for $\mu $ LED display capable of expressing 10-bit gray scale at a refresh rate of 120 Hz.
2 December 2022 in IEEE Transactions on Electron Devices
We present a coplanar amorphous InGaZnO (a-IGZO) synaptic thin film transistor (TFT) with counterclockwise hysteresis using an aluminum oxide (Al $_{\text{2}}$ O $_{\text{3}}\text{)}$ /SiO $_{\text{2}}$ gate insulator (GI). The excitatory postsynaptic current (EPSC), paired-pulse facilitation (PPF), short-term plasticity (STP), and long-term plasticity, which are biological synaptic characteristics, are demonstrated by positive charge trapping in the Al $_{\text{2}}$ O $_{\text{3}}$ layer. Long retention time can be possible by surface charge in the SiO $_{\text{2}}$ , a charge-blocking layer. As a result, multi-level channel conductance can be modulated with positive and negative gate pulses. These results prove synaptic a-InGaZnO TFT with Al $_{\text{2}}$ O $_{\text{3}}$ /SiO $_{\text{2}}$ stack GI for high-density neuromorphic devices.
We report a novel active split structure of low-temperature polysilicon (LTPS) thin film transistor (TFT) on polyimide (PI) substrate showing robust electrical performance under mechanical strain. The compressive and tensile bending tests were carried out with cylinders of radii 3, 2 and 1 mm respectively. The active split TFT exhibits much more stable electrical performance than the conventional TFT. The conventional LTPS TFT shows electrical failure due to the crack generation during tensile or compressive bending test carried out with 1 mm radius cylinder. The split poly-Si islands could resist crack formation/propagation, resulting in a robust electrical performance.
14 April 2025 in ACS Applied Materials & Interfaces
We studied the improvement in the performance of back-channel-etched oxide TFT with a top gate (TG) by Ar/O $_{\text{2}}$ plasma treatment. The generation of oxide nanoparticles in the offset region of amorphous InGaZnO was observed from TEM image upon Ar/O $_{\text{2}}$ plasma treatment. This results in the reduction of resistivity in the offset region and performance improvement of dual-gate oxide TFTs. The field-effect mobility increases from 7.7 to 22.5 cm $^{\text{2}}$ /V $\cdot $ s, and the $\textit{V}_{\text{TH}}$ shift by positive bias temperature stress (PBTS) decreases from 0.7 to 0.3 V. Performance improvement was observed only in structure, where the TG is exposed in air. The performance improvement of the TFTs results in the operation frequency of the ring oscillator (RO) made of the dual-gate TFTs increasing from 17.75 to 113.4 kHz.