Throughout our engineered environment, many materials exhibit a crystalline lattice structure. The orientation of such lattices is crucial in determining functional properties of these structures, including elasticity and magnetism. Hence, tools for determining orientation are highly sought after. Surface acoustic wave velocities in multiple directions can not only highlight the microstructure contrast, but also determine the crystallographic orientation by comparison to a pre-calculated velocity model. This approach has been widely used for the recovery of orientation in cubic materials, with accurate results. However, there is a demand to probe the microstructure in anisotropic crystals - such as hexagonal close packed titanium. Uniquely, hexagonal structure materials exhibit transverse isotropic linear elasticity. In this work, both experimental and simulation results are used to study the discrete effects of both experimental parameters and varying lattice anisotropy across the orientation space, on orientation determination accuracy. Results summarise the theoretical and practical limits of hexagonal orientation determination by linear SAW measurements. Experimental results from a polycrystalline titanium specimen, obtained by electron back scatter diffraction and spatially resolved acoustic spectroscopy show good agreement (errors of ϕ1=5.14° and Φ=6.99°). Experimental errors are in accordance with those suggested by simulation, according to the experimental parameters. Further experimental results demonstrate dramatically improved orientation results (Φ error <1°). Demonstrating the possibility of achieving results near the theoretical limit by strict control of the experimental parameters.
The microstructure of a material defines many of its mechanical properties. Tracking the microstructure of parts during their manufacturing is needed to ensure the designed performance can be obtained, especially for additively manufactured parts. Measuring the microstructure non-destructively on real parts is challenging for optical techniques such as laser ultrasound, as the optically rough surface impacts the ability to generate and detect acoustic waves. Spatially resolved acoustic spectroscopy can be used to measure the microstructure, and this paper presents the capability on a range of surface finishes. We discuss how to describe ’roughness’ and how this influences the measurements. We demonstrate that measurements can be made on surfaces with up to 28 m for a selection of roughness comparators. Velocity images on a range of real surface finishes, including machined, etched, and additively manufactured finishes in an as-deposited state, are presented. We conclude that the is a poor descriptor for the ability to perform measurements as the correlation length of the roughness has a large impact on the ability to detected the surface waves. Despite this issue, a wide range of real industrially relevant surface conditions can be measured.
Spatially resolved acoustic spectroscopy (SRAS) is a laser ultrasound technique used to determine the crystallographic orientation (i.e., microstructure) of materials through the generation and measurement of surface acoustic wave velocity on a sample. Previous implementations have used a grating pattern imaged onto the surface to control the frequency of the generated wave in a single direction—grain orientation can be computed by acquiring wave velocities in different directions on the surface (gathered by physically rotating the grating pattern). This paper reports an advance to this methodology, inspired by single pixel cameras, using a coded grating pattern, created using a spatial light modulator, to excite surface acoustic waves in multiple directions simultaneously. This change to the optical arrangement can simplify the overall system alignment, remove mechanical complexities, and is well suited for point-by-point full orientation imaging, potentially allowing for faster orientation imaging using SRAS microscopy. Improvements to the robustness of measurement may be expected to extend the applicability of SRAS in the materials science field. To demonstrate this methodology, experiments were conducted on isotropic and anisotropic samples.
The measurement of surface acoustic waves (SAWs) is an integral component of nondestructive testing and materials evaluation. The propagation velocity of these SAWs can reveal fundamental properties of the materials, including crystallographic orientation and elasticity, but to utilise these experimental measurements a forward model is required. In this work, we present a general numerical solver for the calculation of SAWs velocities, applicable to all classes of crystallographic symmetry. The method provides robust and efficient evaluation of orientation-dependent SAW velocity surfaces without symmetry-specific assumptions. Simulated results are presented for all crystal classes, with accompanying experimental results where practical, with trigonal and tetragonal results presented for the first time. The calculated velocity surfaces from the forward model show good quantitative agreement with experimental measurements. The numerical performance, limitations of the solver and potential avenues for further improvement are discussed.