The development of novel nanomaterials as highly efficient gas-sensing materials is envisaged as one of the most important routes in the field of gas-sensing research. However, developing stable, selective, and efficient materials for these purposes is a highly challenging task requiring numerous design attempts. In this work, a ZrO2/Co3O4 composite is reported, for the first time, as a gas-sensing material for the detection of ethanol. The sensitive and selective detection of ethanol gas at 200 °C has been demonstrated for the ZrO2/Co3O4 (0.20 wt%/0.20 wt%)-based sensor. Furthermore, the sensor showed a very low response/recovery time of 56 s and 363 s, respectively, in response to a pulse of 20 ppm of ethanol and good stability. The interesting gas-sensing property of ZrO2/Co3O4 can be ascribed to both the porous structure, which facilitates the interaction between the target gas and the sensing site, and the p–p-junction-induced built-in electric field. These results indicate that the ZrO2/Co3O4 composite can serve as a heterostructured nanomaterial for the detection of ethanol gas.
In the present work, a study was carried out with the aim of enhancing the performance of electrochemical biosensors based on Co3O4:Fe2O3 heterojunctions. Specifically, the redox behavior of screen–printed carbon electrodes (SPCEs) modified with Co3O4:Fe2O3 (0.5 wt%:x wt%) nanocomposites, where x ranged from 0.1 to 0.5 wt%, was examined in detail. The hybrid nanocomposites were synthesized using the sol-gel auto-combustion method. Several characterization methods were performed to investigate the morphology, microstructure, and surface area of the pure Co3O4, pure Fe2O3, and the synthesized Co3O4:Fe2O3 nanocomposites. Using cyclic voltammetry (CV) tests, the electrochemical behavior of the modified electrodes toward the dopamine (DA) molecules was investigated. The modified Co3O4:Fe2O3, (0.5 wt%, x = 0.4 wt%)/SPCE resulted in a sensor with the best electrochemical performance toward DA. A high linear relationship between DA concentrations and the faradic current variation (ipa (μA) = 0.0736 + 0.1031 CDA (μA) and R2 = 0.99) was found in the range of 10–100 μM. The sensitivity value was computed to be 0.604 µA µM−1cm−2 and the limit of detection (LOD) 0.24 µM. Based on the characterization and electrochemical results, it can be suggested that the formation of Co3O4:Fe2O3 heterostructures provides a large specific surface area, an increased number of electroactive sites at the metal oxide interface and a p–n heterojunction, thus ensuring a remarkable enhancement in the electrochemical response towards DA.
This paper describes the preparation of Co3O4/CuO composites with vary CuO contents (Co3O4/CuO = 1.0wt%/0.50–1.0wt%) using a simple sol–gel process. According to SEM analysis, the composite samples exhibit a round-like morphology. XRD analysis revealed the formation of CuxCoyOz mixed oxide nanostructures. The composite materials were tested as thick films in conductometric devices for ammonia gas sensing at the optimal temperature of 150 °C. The response of Co3O4/CuO (1.0wt%/1.0wt%) composite was found much higher compared to pure Co3O4 and CuO NPs, suggesting that a synergic interaction occurs between the two metal oxide components in improving ammonia gas sensing capability. According to the findings reported, the design of Co3O4/CuO composite heterojunctions by the simple sol–gel process adopted might be an effective way to increase gas sensing toward ammonia gas at mild temperature.
Ag2O-loaded Co3O4 composites (Ag2O/Co3O4) were prepared by the sol–gel auto-combustion method. Their morphology, microstructure, and textural properties were characterized by scanning electron microscopy (SEM) coupled with energy-dispersive X-ray spectroscopy (EDX), Fourier transform infrared spectroscopy (FTIR), and Brunauer–Emmett–Teller (BET) analysis. The composites were evaluated as conductometric sensors for hydrogen (H2). The Ag2O/Co3O4−0.5 sensor showed an enhanced response to H2 over the investigated concentration range of 2000–10,000 ppm at an optimal operating temperature of 125 °C compared with pure Co3O4. The electrocatalytic activity of the composites was also investigated after spray-coating them onto screen-printed carbon electrodes (SPCEs). Cyclic voltammetry (CV) showed an enhanced response to uric acid for the Ag2O/Co3O4−1.0/SPCE compared with Co3O4/SPCE, with a sensitivity of 2.6 μA μM−1 cm−2, satisfactory reproducibility and stability, and a limit of detection (LoD) of 147 nM. These findings suggest that Ag2O/Co3O4 composites are promising materials for both gas and electrochemical sensing.
Co3O4-NiO nanocomposites at different molar ratios have been prepared using a simple sol-gel method. The composite were used as electrode materials for detecting L-tyrosine, modifying a screen printed electrode (SPCE). The electrochemical sensor response to L-Tyrosine (concentration-Tyr) in PBS pH=7.4 and at [0μM-100μM] has been investigated by using cyclic voltammetry (CV).Results obtained demonstrated that the composite Co3O4-NiO/SPCE sensors exhibit good electroanalytical performances, with a maximum of sensitivity exibited at a Co3O4:NiO ratio = 1.