This paper provides an in-depth analysis of photovoltaic (PV) system control within the MATLAB/Simulink environment, focusing on optimizing Maximum Power Point Tracking (MPPT) algorithms for enhanced efficiency under dynamic conditions. While conventional algorithms are widely used, their performance is limited under fluctuating conditions. To address this, we propose a novel hybrid approach combining Incremental Conductance with Fuzzy Logic Control (FLC), utilizing two innovative input variables: the sum of Conductance and Incremental Conductance (SInC) and its rate of change (CSI). The performance of the proposed algorithm, in comparison to other hybrid FLC methods, is evaluated through simulations using a boost converter under dynamic conditions, including abrupt irradiance changes and load variations. The results demonstrate that the proposed hybrid algorithm achieves superior performance, with an average MPPT efficiency of 97.7%, a convergence time of 53.5 ms, and an RMS of 97.8%, outperforming both conventional and other hybrid techniques. This work advances PV system control by providing a robust and adaptive solution for maximizing power extraction under diverse operating conditions.
The reliable operation of power transformers is essential for grid stability, yet existing fault detection methods often suffer from inaccuracies and high false alarm rates. This study introduces a machine learning framework leveraging voltage signals for early fault detection. Simulating diverse fault conditions—including single line-to-ground, line-to-line, turn-to-ground, and turn-to-turn faults—on a laboratory-scale three-phase transformer, we evaluated decision trees, support vector machines, and logistic regression models on a dataset of 6000 samples. Decision trees emerged as the most effective, achieving 99.90% accuracy during 5-fold cross-validation and 95% accuracy on a separate test set of 400 unseen samples. Notably, the framework achieved a low false alarm rate of 0.47% on a separate 6000-sample healthy condition dataset. These results highlight the proposed method’s potential to provide a cost-effective, robust, and scalable solution for enhancing transformer fault detection and advancing grid reliability. This demonstrates the efficacy of voltage-based machine learning for transformer diagnostics, offering a practical and resource-efficient alternative to traditional methods.
Photovoltaic Water Pumping Systems (PVWPS) have become increasingly important as a renewable energy solution in rural areas, providing energy independence, cost savings, and environmental friendliness. This system has two main controllers. The first controller is employed to maximize power extraction from the PV array by controlling the duty ratio of the DC-DC boost converter. The second controller is responsible for regulating the operation of the induction motor through the switching pulses of the Voltage Source Inverter (VSI). These two controllers play an essential role in the system, which increases efficiency and performance. Therefore, the innovative aspect of this work consists of introducing Artificial Neural Networks (ANNs) based on each PVWPS controller. On the one hand, ANN-based MPPT is implemented to ensure optimal performance of the PV array under varying irradiation levels. On the other hand, to overcome the defects and problems caused by Direct Torque Control (DTC), such as flux and torque ripples, high switching frequency, and challenges at low speeds, an ANN-based DTC is proposed in which each of the hysteresis comparators, switching table, and speed controller in the DTC are replaced by ANN controllers. The PVWPS based on the proposed controls is thoroughly modeled and simulated using MATLAB/Simulink software and validated using dSPACE DS1104 Board. The results demonstrate significant improvements, including a 75.51% reduction in flux ripples, a 77.5% reduction in torque ripples, a 44.79% improvement in response time, and an increase in the water quantity. Furthermore, the Real-Time simulation and visualization obtained are consistent with the simulation outcomes.
Electric vehicles (EVs) have become a feasible alternative to conventional vehicles due to their technical and environmental benefits. The rapid penetration of EVs might cause a significant impact on the distribution system (DS) due to the adverse effects of charging the EVs and grid integration technologies. In order to compensate for an additional EV load to the existing load demand on the DS, the distributed generators (DGs) are integrated into the grid system. Due to the stochastic nature of the DGs and EV load, the integration of DGs alone with the DS can minimize the power losses and increase the voltage level but not to the extent that might not improve the system stability. Here, the EV that acts as a load in the grid-to-vehicle (G2V) mode during charging can act as an energy source with its bidirectional mode of operation as vehicle-to-grid (V2G) while in the discharging mode. V2G is a novel resource for energy storage and provision of high and low regulations. The article proposes a smart charging model of EVs, estimates the off-load and peak load times over a period of time, and allocates charging and discharging based on the constraints of the state of charge (SoC), power, and intermittent load demand. A standardized IEEE 33-node DS integrated with an EV charging station (EVCS) and DGs is used to reduce the losses and improve the voltage profile of the proposed system. Simulation results are carried out for various possible cases to assess the effective utilization of V2G for stable operation of the DS. The cost–benefit analysis (CBA) is also determined for the G2V and V2G modes of operation for a 24-h horizon.
Power system stability is managed through various control loops, including the Automatic Voltage Regulator (AVR), which regulates the terminal voltage of synchronous generators. This study integrated Fuzzy Logic Control (FLC) and a Proportional–Integral–Derivative controller with Filtered derivative action (PIDF) to propose a hybrid Fuzzy PIDF controller enhanced by Fractional-Order Proportional-Derivative (FOPD) for AVR applications. For the first time, the newly introduced Sand Cat Swarm Optimization (SCSO) algorithm was applied to the AVR system to tune the parameters of the proposed fuzzy controller. The SCSO algorithm has been recognized as a powerful optimization tool and has demonstrated success across various engineering applications. The well-known Particle Swarm Optimization (PSO) algorithm was also utilized in this study to optimize the gains of the proposed controller. The Fuzzy PIDF plus FOPD is a novel configuration that is designed to be a robust control technique for AVR to achieve an excellent performance. In this research, the Fuzzy PIDF + FOPD controller was optimized using the PSO and SCSO algorithms by minimizing the Integral Time Absolute Error (ITAE) objective function to enhance the overall performance of AVR systems. A comparative analysis was conducted to evaluate the superiority of the proposed approach by benchmarking the results against those of other controllers reported in the literature. Furthermore, the robustness of the controller was assessed under parametric uncertainties and varying load disturbances. Also, its robustness was examined against disturbances in the control signal. The results demonstrate that the proposed Fuzzy PIDF + FOPD controller tuned by the PSO and SCSO algorithms delivers exceptional performance as an AVR controller, outperforming other controllers. Additionally, the findings confirm the robustness of the Fuzzy PIDF + FOPD controller against parametric uncertainties, establishing its potential for a successful implementation in real-time applications.
The present study examines AI techniques to reduce the cost and CO2 emissions for designing and controlling microgrid at minimum cost and providing a power supply to a residential complex of 100 units. Three AI techniques, Genetic Algorithm (GA), Artificial Bee Colony (ABC), and Ant Colony Optimization (ACO), are employed to optimize the optimal composition of energy sources based on solar energy and wind energy, battery storage, and load profiles. GA, from natural selection, is constantly seeking the best configuration. ABC models honeybee foraging behavior to achieve efficient exploration, and ACO models ant colony decision-making to achieve optimal energy configuration. These AI models maximize the use of renewable energy, reduce wastage, and improve microgrid resilience and responsiveness to supply and demand fluctuations. Experiments demonstrate the revolutionary potential of AI to control microgrids. The optimization achieves the lowest electricity cost of 0.037 USD/kWh, a reduction by 67% from Fez’s reference cost (0.115 USD/kWh) and guarantees a supply of power. These results illustrate the ability of AI to power cheap and clean energy systems.