With the introduction of the working principle of coupled resonators, the coupled bulk acoustic wave (BAW) Micro-Electro-Mechanical System (MEMS) resonators have been attracting much attention. In this paper, coupled BAW MEMS resonators are discussed, including the coupling theory, the actuation and sensing theory, the transduction mechanism, and the applications. BAW MEMS resonators normally exhibit two types of vibration modes: lateral (in-plane) modes and flexural (out-of-plane) modes. Compared to flexural modes, lateral modes exhibit a higher stiffness with a higher operating frequency, resulting in a lower internal loss. Also, the lateral mode has a higher Q factor, as the fluid damping imposes less influence on the in-plane motion. The coupled BAW MEMS resonators in these two vibration modes are investigated in this work and their applications for sensing, timing, and frequency reference are also presented.
This paper presents a platform for weakly coupled mechanical and electrical resonators with arbitrary tunability. Two- and three-degree-of-freedom (DoF) weakly coupled resonator systems are demonstrated experimentally with this platform, showing excellent tuning and matching flexibility. Fully electrical coupling logic circuitry gives the proposed system better adjustability and lower susceptibility to fabrication tolerances compared to purely mechanical weakly coupled resonators. Due to its mother/daughter board structure and the simplicity of the coupling logic, the proposed system can easily be extended to any-DoF systems.
This paper reports on a gas sensor based on two bulk acoustic wave (BAW) resonators electrically coupled with a tuneable capacitor. The weak coupling strength was tuned to its optimal value (achieving maximum sensitivity) by varying the capacitance (without complex filtering, a control circuit as required in the state of the art). A gas sensor was developed based on the electrically coupled BAW resonators by functionalizing one of the resonators with zeolitic imidazolate framework-8 (ZIF-8). It featured a quality (Q) factor of ~2.2 k in air and a resonance frequency of ~6.32 MHz. Such a simple coupling mechanism can be tuned and further extended to coupled resonators in other domains.
3 June 2026 in IEEE Transactions on Industrial Electronics
Signal fusion between various sensors has been explored to enhance the robustness and resolution, leveraging their complementary characteristics. In general, a higher correlation between sensors leads to more efficient fusion. This work presents a silicon resonant accelerometer (SRA) that enables tunable noise correlation between capacitive and piezoresistive dual transductions. The accelerometer comprises a double clamped beam resonator with piezoresistive gauges and capacitive electrodes, allowing simultaneous transduction outputs of both signals. Through tuning the thermal bias applied to the piezoresistive gauges, the transduction gain of the piezoresistive signal can be tuned, enabling real-time control of the correlation between the two signals. The real-time frequencies demodulated from the signals with variable correlation are fused by using a general 2nd-order Kalman filter algorithm. Experimental results demonstrate that the fused output achieves a resolution of 0.49 µg/√Hz. This represents an improvement of approximately 10.45 dB compared with capacitive detection alone. Meanwhile, the fused signal preserves the broad bandwidth of ∼1150 Hz provided by piezoresistive detection. This highlights the effectiveness of noise correlation manipulation for enhancing sensor performance by output signal fusion.