Researches on glass welding using tightly focused ultrafast lasers have attracted much attention. However, optical systems with low numerical aperture (NA) in laser material processing are commonly used in industry applications. Transmission welding of two fused silica glass plates is performed by using picosecond laser irradiation with low NA in this study. The welding strength under different process parameters such as focal position, pulse energy, and scanning velocity is measured. The role of the modification in welding process is demonstrated through the interior morphology in single-piece glass samples. A model is presented to predict the position of the bottom tip of the modification (BTM). The model considers the propagation property of the laser beam and the incubation effect of modification threshold. The numerical and experimental positions of BTM are compared. The model can give an idea for selecting process parameters to the achievement of glass welding for low NA optical system in ultrafast laser welding.
Because of rapid heating, cooling, and solidification during metal additive manufacturing (AM), the resulting products exhibit strong anisotropy and are at risk of quality problems from metallurgical defects. The defects and anisotropy affect the fatigue resistance and material properties, including mechanical, electrical, and magnetic properties, which limit the applications of the additively manufactured components in the field of engineering. In this study, the anisotropy of laser power bed fusion 316L stainless steel components was first measured by conventional destructive approaches using metallographic methods, X-ray diffraction (XRD), and electron backscatter diffraction (EBSD). Then, anisotropy was also evaluated by ultrasonic nondestructive characterization using the wave speed, attenuation, and diffuse backscatter results. The results from the destructive and nondestructive methods were compared. The wave speed fluctuated in a small range, while the attenuation and diffuse backscatter results were varied depending on the build direction. Furthermore, a laser power bed fusion 316L stainless steel sample with a series of artificial defects along the build direction was investigated via laser ultrasonic testing, which is more commonly used for AM defect detection. The corresponding ultrasonic imaging was improved with the synthetic aperture focusing technique (SAFT), which was found to be in good agreement with the results from the digital radiograph (DR). The outcomes of this study provide additional information for anisotropy evaluation and defect detection for improving the quality of additively manufactured products.
Laser-induced periodic surface structures have been extensively studied for various materials because of their promising applications. For these applications, uniform rippled structures with well-defined large areas are required. However, the efficient fabrication of uniform rippled structures is a challenge. Morphologies of rippled structures of multiple-shot-ablated regions considerably affect the processing efficiency of uniform rippled structures because incubation effects are crucial. In this study, the effects of a pulse number and irradiation modes on surface morphologies of rippled structures on the titanium surface are experimentally studied. The experimental results indicate the following: (1) Samples first irradiated using several shots and then using remaining shots by designing laser pulse irradiation modes exhibit improved surface morphologies, such as larger ablation areas and finer rippled structures. (2) When the pulse number in the first series is less than that in the second series, the rippled structures are characterized using larger areas and periods. (3) The ablated areas with rippled structures increase with the increasing number of pulses. (4) The periods of ripples reduce with the increasing number of pulses. Therefore, according to different requirements, uniform rippled structures can be efficiently fabricated and adjusted using the designed laser pulse modes and pulse number.