Clearcoats provide long-term aesthetics and protection for underlying coating systems, increasing product lifetimes. However, organic clearcoats are predominantly produced using fossil-fuel feedstocks. In search of a sustainable alternative, an experimental investigation was conducted on the development of glass-like clearcoats produced using the sol-gel process. The processing of sol-gel clearcoats over a pigmented polyurethane coating was studied by modifying the sol-gel solution pH, ageing, curing, precursor chemistry and deposition techniques. Under optimal formulation and processing conditions, defect-free sol-gel clearcoats were produced that have the potential to be scaled up to a coil-coating line using existing technologies. Mechanical testing demonstrated the coatings had excellent adhesion, hardness, and flexibility. Furthermore, accelerated laboratory weathering tests revealed the sol-gel coatings had superior degradation resistance compared to the organic coatings tested, resulting in negligible colour changes and higher gloss retention after 4000 h of exposure. The durability and environmental benefits of sol-gel clearcoats highlight their potential as a replacement for traditional organic clearcoats in a variety of applications.
This work implements computational chemistry as a screening tool to aid in the coating and resin formulation process. Conceptual Density Functional theory (DFT) reactivity descriptors like the global chemical hardness and the dual descriptor Fukui function identify the tendency of polyester-melamine coatings to undergo electrophilic and nucleophilic attack during weathering exposure. Coatings were subjected to natural and accelerated weathering tests, with periodic infrared spectroscopy, colour, and gloss measurements to assess for the degree of changes brought about through photodegradation. It was found that the number of attack sites in the atomistic models, when weighted as a function of the polyester : crosslinker ratio, effectively ranked the degradation of different coating systems upon weathering. This ranking matched the performance of the coatings subjected to both accelerated and natural weathering, showing affinity with naturally weathered samples, and matching in all areas. The results were shown to demonstrate significant correlation, being over R2 = 0.8 for 7 of the 8 measured areas, and greater than R2 = 0.9 for 6 compared areas. Comparison of computationally derived and experimentally acquired results showed that the performance of naturally weathered samples was matched across all areas by the computational rankings, showing superior correlation than that observed between natural and accelerated weathering tests. This indicates that the method utilised within this work provides a novel, cost-effective alternative to evaluate the projected performance of selected coatings, while enabling a computationally accelerated platform for more sustainable low-degradation coatings without the requirement of long-term weathering tests.
Organically coated steels are widely used in applications in which they are subjected to the natural environment and therefore require excellent corrosion resistance. Organic clearcoats are typically employed as a barrier that improves the overall corrosion resistance; however, they are typically derived from fossil fuel-based feedstock. A more sustainable alternative could be possible using sol–gel coatings. The application of a simple tetraethoxysilane (TEOS)-based sol–gel was applied to polyurethane-coated steels using a spray coater. The concentration of TEOS was altered to produce coatings containing either 2.5% or 10%. The 10% TEOS resulted in dense, homogeneous coatings that offered a significant improvement in corrosion resistance compared to an uncoated substrate. Whereas the 2.5% TEOS coatings were inhomogeneous and porous, which indicated a limitation of concentration required to produce a uniform coating. The successful demonstration of using a simple TEOS-based coating to improve the corrosion resistance of organically coated steel highlights the potential for further investigation into the use of sol–gels for these applications.