Wanbo Wang

Dr. Wanbo Wang


Research Focus & Metrics

Academic Career Length

4Years (2023-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
8 June 2023 in Actuators
Verified
Journal Article
Open access
PDF file
JPJiaxin Pan
Jiaxin Pan
WWWanbo Wang
Wanbo Wang
CQChen Qin
Chen Qin
XWXunnian Wang
Xunnian Wang
QSQixiang Sun
Qixiang Sun
XZXin Zhang
Xin Zhang
Combined blowing was performed on a Hybrid Wing Body (HWB) aircraft through wind tunnel testing at a Reynolds number of 1.75 × 106. The full cycle of separation and reattachment under the control of combined blowing was implemented using Computational Fluid Dynamics (CFD), and the mechanism of combined blowing inhibiting separation was analyzed. The aerodynamic characteristics of the baseline and the independent effects of the blown deflected trailing edge (TE), blown leading edge (LE), and combined blowing on the TE and LE were investigated. The results clearly show that combined blowing can inhibit the development of cross-flow, reduce the accumulation of a boundary layer at the tip, and inhibit the flow separation effect. The effect of using seamless simple flaps alone to increase the lift is limited; blowing control is required to enhance the lift further. Applying the blown deflected TE can improve the lift linear segment, so that 30° flap achieves the lift gain of 40° flap without control, while the drag coefficient is approximately 0.02 smaller, but the stall gradually advances. Using the blown LE can significantly increase the stall angle from 12° to 18°. However, the lift linear segment remains unaffected. In particular, combined blowing can achieve the control effect of improving the lift linear segment, delaying stall, and decreasing drag. Moreover, the maximum lift coefficient is approximately 0.19, and the lift-to-drag ratio increment in the control state with a 30° flap deflection angle is above 2.2 in the angle of attack range of 4° to 12° compared to the uncontrolled state with a 40° flap deflection angle.

9 September 2023 in Applied Sciences
Verified
Journal Article
Open access
PDF file
SLShuai Luo
Shuai Luo
LLLinkai Li
Linkai Li
KCKeming Cheng
Keming Cheng
YGYunsong Gu
Yunsong Gu
RFRuishan Fang
Ruishan Fang
WWWanbo Wang
Wanbo Wang
To provide sufficient lift during takeoff and landing, large aircraft are equipped with complicated high-lift devices. The use of simple flaps coupled with active flow control (AFC) can achieve lift improvement while reducing mechanical structure and weight. The present study focuses on verifying the feasibility and effectiveness of simple flaps combined with sweeping jet flow control. An experimental study on the AFC of flaps, using sweeping jets, was carried out using a NASA SC(2)-0410 supercritical airfoil wind-tunnel model at Re = 2.0 × 105 (with velocity V = 10 m/s). In the experiment, the wing angle of attack (α) ranged from 3 to 18°, and the flap deflection angle (δ) ranged from 0 to 30°; the aerodynamic characteristics and surface pressure characteristics of the wing at typical working conditions were analyzed. Using sweeping jets to control the flow on the flaps, the momentum coefficients (for three actuator groups) of the jet are 0.8%, 3.6%, and 8.2%, respectively, and the maximum lift coefficient was increased by approximately 33%. The influence of the sweeping jet flow rate on the aerodynamic performance of the airfoil is analyzed. There are two main reasons for the lift coefficient increase caused by sweeping jet flow: an extra suction peak near the flap and a suction peak increase near the leading edge area caused by induced flow.

25 August 2025 in Experiments in Fluids
Verified
Journal Article
Closed access
PDF file
XZXinhai Zhao
Xinhai Zhao
WWWanbo Wang
Wanbo Wang
CQChen Qin
Chen Qin
JPJiaxin Pan
Jiaxin Pan
QSQiqiang Sun
Qiqiang Sun

13 March 2025 in Aerospace
Verified
Journal Article
Open access
PDF file
YSYan Shao
Yan Shao
WWWanbo Wang
Wanbo Wang
JSJiao Sun
Jiao Sun
WCWenyi Chen
Wenyi Chen
XZXinhai Zhao
Xinhai Zhao
JPJiaxin Pan
Jiaxin Pan
Both propeller slipstream and flap jet flow can significantly increase the aircraft lift coefficient. To establish design principles for efficient lift enhancement via jet flow under the influence of slipstream, wind tunnel experiments are conducted on a wing with propeller slipstream and jet flow. Force measurements using a balance and flow field measurements using hot-wire anemometry are employed to investigate the effects of different jet flow distribution methods on lift enhancement. The results indicate that the coupling of slipstream and jet flow effects can significantly increase wing lift. The stronger the slipstream effect, the more pronounced the lift enhancement under the same momentum coefficient. At the same thrust coefficient, a higher momentum coefficient is required in the slipstream-affected region to suppress airflow separation. Under the same jet flow rate, increasing the momentum coefficient in the slipstream-affected region can significantly improve lift enhancement. At the thrust coefficient of 0.46 and the momentum coefficient of 0.1, the optimized jet flow distribution method achieved a 52.6% greater lift enhancement compared to the spanwise uniform jet flow distribution method.

29 September 2025 in Fluid Dynamics
Verified
Journal Article
Closed access
PDF file
PXPan Jia Xin
Pan Jia Xin
WWWanbo Wang
Wanbo Wang
YWY. Wang
Y. Wang
XZX. Zhang
X. Zhang
PSP. Shen
P. Shen
FTF. Tong
F. Tong
The aerodynamic characteristics of amphibious aircraft in real wind and wave conditions are studied. An experimental investigation of jet lift control on airfoil in near-wave water is conducted. The novel wind-water tunnel testing methods are proposed. The study focuses on the aerodynamic performance of the basic airfoil, the lift enhancement performance of the jet, and ground/water surface effects. The results show that flap jet flow significantly increases the lift coefficient of the airfoil. When Cμ = 0.024, the lift increase is equal to approximately 48.3%. As compared to steady jet flow, unsteady pulsed jet flow has the greater lift enhancement potential, with a lift increase of about 32.5% at Cμ = 0.015. The dimensionless wave height A1 in the range from 0.653 to 0.928 results in a smoother stall characteristic compared to A1 = 0.307. The higher wave motion adversely affects the lift enhancement of the airfoil under jet control.

21 November 2023 in Actuators
Verified
Journal Article
Open access
PDF file
JPJiaxin Pan
Jiaxin Pan
WWWanbo Wang
Wanbo Wang
XWXunnian Wang
Xunnian Wang
CLChaoqun Li
Chaoqun Li
XZXinhai Zhao
Xinhai Zhao
KTKun Tang
Kun Tang
To investigate the flow control characteristics of antiphase pulsed jet technology and explore a more efficient method to control unsteady flow with minimal impact on flow turbulence, wind tunnel experiments were conducted. The aim was to address the issue of flow separation control on the surface of a cylindrical model. The model had a diameter of 100 mm, and an experimental setup utilizing an antiphase pulsed jet excitation was developed. The optimisation of unsteady jet control involved adjusting parameters such as jet momentum coefficient, slot position, and excitation frequency. The flow separation control effect on the cylinder surface was compared between in-phase and antiphase pulsed jet using a particle image velocimetry (PIV) technique. The mechanisms of flow control for these two methods were analysed. The results showed that in still air, increasing the jet momentum led to a gradual decrease in the high-velocity region, which also moved away from the wall. Under incoming flow conditions, positioning the slot closer to the separation point resulted in better flow separation control, particularly when the excitation frequency matched the main flow frequency. Both in-phase and antiphase pulsed jet excitations effectively suppressed flow separation. In the near-wall region within the symmetric plane between the two slots, the antiphase excitation reduced the root mean square of velocity fluctuations by approximately 1.9% and increased the average velocity by approximately 15.5% compared to in-phase pulsed jet excitation. In-phase pulsed jets exhibited low-frequency, high-velocity characteristics near the separation point, while antiphase pulsed jets, due to the alternating discharge of the two jets, had a lesser impact on the flow field turbulence.