Both propeller slipstream and flap jet flow can significantly increase the aircraft lift coefficient. To establish design principles for efficient lift enhancement via jet flow under the influence of slipstream, wind tunnel experiments are conducted on a wing with propeller slipstream and jet flow. Force measurements using a balance and flow field measurements using hot-wire anemometry are employed to investigate the effects of different jet flow distribution methods on lift enhancement. The results indicate that the coupling of slipstream and jet flow effects can significantly increase wing lift. The stronger the slipstream effect, the more pronounced the lift enhancement under the same momentum coefficient. At the same thrust coefficient, a higher momentum coefficient is required in the slipstream-affected region to suppress airflow separation. Under the same jet flow rate, increasing the momentum coefficient in the slipstream-affected region can significantly improve lift enhancement. At the thrust coefficient of 0.46 and the momentum coefficient of 0.1, the optimized jet flow distribution method achieved a 52.6% greater lift enhancement compared to the spanwise uniform jet flow distribution method.
In order to improve the separation control effect of an oscillating jet, the external flow field of the actuators and the wing wake are obtained via hot-wire measurements to optimize the actuator and achieve wing separation flow control. The optimization objectives are to improve the sweeping uniformity and range of the jet. In the present study, the PCA method is used for the modal decomposition of the velocity distribution. The modal-based actuator evaluation parameters are proposed, and the kriging surrogate models of the modal coefficients (principal components) on the actuator parameters are established. The multi-objective genetic algorithm was utilized to complete the optimization of the actuator, and the effect of flow separation control on the wing was verified. The results show that three patterns exist in the time-averaged velocity distribution of the external flow field: unimodal, broad and bimodal, from unimodal to bimodal, the degree of the jet sweeping uniformity gradually decreases, and the sweeping range gradually increases. The pattern of the velocity distribution modals affects the degree of jet sweeping uniformity, while the distance of the modal peaks affects the jet sweeping range. The two evaluation parameters are negatively correlated: insufficient sweeping range or poor sweeping uniformity of the jet are not conducive to wing separation flow control, and the two must be coordinated to achieve the optimal control effect.