Building-integrated flexible resources can offer economical availability to accommodate high-penetrated renewable energy sources (RESs), which can be potentially coordinated to achieve cost-effective supply. This paper proposes a resilience-oriented planning model of urban distribution system source–network–load–storage in the context of high-penetrated building-integrated resources. In this model, source–network–load–storage resources are cost-optimally planned, including the lines, soft open point (SOP), building-integrated photovoltaics (BIPVs), building-integrated wind turbine (BIWT), building-integrated energy storage system (ESS), etc. To enhance fault recovery capability during extreme faults, fault scenarios are incorporated into the distribution system operation via coupled multiple recovery stages. The resilience-oriented planning is a thorny problem due to its source–network–load–storage couplings, normal-fault couplings, etc. The original resilience-oriented planning is reformulated as a mixed-integer linear programming (MILP) problem, which can then be solved with a two-stage method and evaluated via a multi-dimensional evaluation metrics. The proposed planning methodology is benchmarked over a Portugal 54-node urban distribution system to verify the superiority and effectiveness on the system economy and resilience levels. Case studies show that the proposed methodology can exploit the optimal synergies of different source–network–load–storage components and enhance system dispatchability.
With the rapid increase in the renewable energy penetration rate in distribution networks, the volatility and uncertainty on the power supply side have become prominent; thus, it is urgent to fully utilize the regulation potential of the flexible load on the user side to maintain the dynamic balance of power. A multi-level evaluation method for flexible load regulation potential based on ensemble clustering is proposed in the paper. First, a data-driven approach based on ensemble clustering is adopted to quantify the user-level regulation potential of flexible load. Second, the bus-level regulation potential of the flexible load is obtained by aggregation calculation. Finally, a quantitative evaluation of the system-level regulation potential of flexible load in the distribution network is realized by constructing three optimization models with different objectives. Case studies show that the proposed method can effectively evaluate the regulation potential of flexible load in the distribution network from multiple levels, i.e., user level, bus level, and system level.
High penetration of photovoltaic generation brings rapid voltage variation, uncertain reverse power flow, and increased network loss to active distribution networks. Voltage regulation becomes more challenging when PV output, load demand, and storage operation change simultaneously. To improve voltage security and operating economy under stochastic operating conditions, an adaptive coordinated control method named SMAC is proposed for PV storage voltage regulation. The control problem is formulated as a Markov decision process, where the operating state includes load demand, PV generation, storage state of charge, and voltage security information. The control action includes PV inverter reactive power, energy storage active power, and capacitor bank switching command. A safety margin guided reward function is constructed by integrating voltage deviation, voltage limit violation, active power loss, and soft low voltage risk. Different from violation driven control, the soft margin term provides early risk guidance before nodal voltages reach the lower security boundary. Within the actor critic framework, the actor learns online coordinated regulation actions, while the critic evaluates long term return related to voltage security and network loss. SMAC further introduces voltage security indicators, a safety-margin-guided reward function, and a hybrid coordinated action design for preventive voltage regulation under uncertain PV-load conditions. Case studies are conducted on a modified IEEE 33 bus distribution system with five PV units, one energy storage system, and one capacitor bank. Across five independent runs, SMAC achieves an average maximum voltage deviation of 0.0408 p.u. and increases the average minimum nodal voltage to 0.9592 p.u. No voltage violation is observed in any of the independent runs. The average network loss is reduced to 888.94 kWh. These statistical results demonstrate that SMAC provides stable preventive voltage regulation and favorable operating economy under different random initializations.
In remote power supply scenarios, long-distance transmission cables introduce voltage drops due to their inherent impedance, leading to load undervoltage. Additionally, dynamic current variations may cause significant fluctuations in load voltage, potentially exceeding the allowable voltage range. To address these challenges, this paper proposes a sinusoidal-excitation-based impedance detection method, which can achieve source-side single-ended impedance detection of the cable. Based on the detection results, a composite control strategy is developed to compensate for both steady-state and transient voltage drops, effectively mitigating the impact of current variations on load-voltage stability. The operating principle and parameter design are analyzed. Experimental testing is carried out using a hardware prototype with an equivalent R-L test loop, and the verification and comparative results indicate that the proposed method effectively resolves voltage drop and response delay issues caused by long cables, achieving accurate and stable remote voltage regulation.
The Gaussian Mixture Model (GMM) is commonly used to formulate the probabilistic model for quantifying uncertainties in renewable generation. However, traditional static probabilistic models may not efficiently adapt and learn from newly forecasted and measured data. In this paper, we propose a recursively updated probabilistic model that leverages a recursive estimation method to update the parameters of the GMM based on continuously arriving data of renewable generation. This recursive modeling approach effectively incorporates new observations while discarding outdated samples, enabling the tracking of time-varying uncertainties in renewable generation in an incremental manner. Furthermore, we introduce an extra calibration stage to enhance the long-term accuracy of the probabilistic model after a large number of incremental updates. The main contribution is to address the potential degradation of performance caused by suboptimal incremental updates accumulated over time. Numerical tests demonstrate that the proposed model achieves 5–10% higher log likelihood in characterizing renewable generation uncertainties compared to purely recursive models, while reducing computational time by three to four orders of magnitude (1000 to 10,000 times) relative to conventional EM. These results highlight the proposed model’s suitability for real-time probabilistic modeling of renewable generation, with potential applications in system operation.
In the transactional processes within a multi-building microgrid system, it is imperative to safeguard stakeholders’ interests and ensure stable, economically efficient operation. Therefore, this paper proposes an integrated interactive control of distribution systems with multi-building microgrids based on game theory. Initially, an interactive framework encompassing superior power grids, distribution network operators, and multi-building microgrids is proposed. This framework establishes a master–slave game model between distribution network operators and multi-building microgrids. Additionally, it introduces the concept of Soft Open Points between building microgrids to enhance system operational safety while also reducing economic costs for distribution network operators. Subsequently, to maintain solution accuracy and optimality, it employs linearization and cone relaxation methods to transform the original model into a mixed-integer second-order cone programming model. Furthermore, it enhances an iterative search method and the price mechanism based on supply and demand ratios. The revised price mechanism serves to boost the participation of building microgrid users in energy regulation, while the iterative search method effectively resolves the equilibrium point of interest among all game participants. Finally, a simulation analysis is conducted on an IEEE-33 test system, and the effectiveness of the proposed strategy is verified by comparing three schemes.