This contribution demonstrates photonic crystal waveguides generated within bulk planar sapphire substrates. A femtosecond laser is used to modify the refractive index in a hexagonal pattern around the pristine waveguide core. Near-field measurements reveal single-mode behavior at a wavelength of 1550 nm and the possibility to adapt the mode-field diameter. Based on far-field examinations, the effective refractive index contrast between the pristine waveguide core and depressed cladding is estimated to 3·10−4. Additionally, Bragg gratings are generated within the waveguide core. Due to the inherent birefringence of Al2O3, the gratings exhibit two distinct wavelengths of main reflection. Each reflection peak exhibits a narrow spectral full width at a half maximum of 130 pm and can be selectively addressed by exciting the birefringent waveguide with appropriately polarized light. Furthermore, a waveguide attenuation of 1 dB cm−1 is determined.
Sapphire is a robust and wear-resistant material. However, efficient and high-quality micromachining is still a challenge. This contribution demonstrates and discusses two novels, previously unreported approaches for femtosecond laser-based micromachining of rotational-symmetric sapphire workpieces, whereas both methods are in principal hybrids of laser scanning and laser turning or laser lathe. The first process, a combination of a sequential linear hatch pattern in parallel to the workpiece’s main axis with a defined incremental workpiece rotation, enables the fabrication of sapphire fibers with diameters of 50 μm over a length of 4.5 mm. Furthermore, sapphire specimens with a diameter of 25 μm over a length of 2 mm can be fabricated whereas an arithmetical mean height, i.e., Sa parameter, of 281 nm is achieved. The second process combines a constant workpiece feed and orthogonal scanning with incremental workpiece rotation. With this approach, workpiece length limitations of the first process are overcome and sapphire fibers with an average diameter of 90 µm over a length of 20 cm are manufactured. Again, the sapphire specimen exhibits a comparable surface roughness with an average Sa value of 249 nm over 20 cm. Based on the obtained results, the proposed manufacturing method paves an innovative and flexible, all laser-based way towards the fabrication or microstructuring of sapphire optical devices, and thus, a promising alternative to chemical processes.
This article discusses the process of the laser turning of rotational symmetric, cylindrical components using ultrashort laser pulses with respect to the geometrical conditions and the resulting energy distribution during the laser turning process. As a result, process predictions and potential process optimizations are feasible. Particular attention is drawn to the laser spot formation on the cylindrical surface of the work piece in conjunction with the positioning of the laser beam relative to the rotation axis of the specimen. Based on fundamental calculations and experimental results, an optimum processing strategy is discussed, whereat the use of a trepanning optic in the laser turning process and the forming of a particular surface structure is additionally being issued.
We report on a novel approach for the monitoring of tangential laser turning with ultrashort laser pulses. By using an ultra-sonic sensor consisting of a membrane-free optical microphone, the current state of the ablation process can be analyzed, potentially enabling a real-time automated regulation. With its high sensitivity, bandwidth, and sampling rate, it is an ideal tool for process monitoring. The material ablation caused by focused femtosecond laser pulses produces distinct sound waves, which can be detected by the optical microphone. The diameter reduction of a rotating cylindrical workpiece during the laser turning process with ultrashort laser pulses results in a variation in the acoustic emissions. From this, properties like the state of the machining progress can be inferred.