The tribological performance of graphene oxide (GO) nanosheets, modified biodiesel soot (MBS) nanoparticles, and their mixture (MBS–GO) nanoparticles as lubricant additives in water was evaluated using a reciprocating ball-on-plate tribometer. The effects of different mass ratios of GO to MBS, additive concentrations, and loads, as well as corresponding lubrication mechanisms, were studied. The tribological measurements showed that the water-containing 0.5 wt% additives at a mass ratio of 60:40 (GO to MBS) resulted in larger reductions in friction coefficient (69.7%) and wear volume (60.5%) than water. Owing to the synergistic effect of GO nanosheets and MBS nanoparticles, the MBS–GO aqueous sample showed superior lubricating properties compared to water as well as GO and MBS aqueous samples. The good tribological properties of MBS–GO nanoparticles in water are attributed to the formation of a tribofilm of hybrid nanoparticles that effectively protects the friction interface. Moreover, the MBS nanoparticles can provide lubrication by acting as ball bearings.
Here, a novel copper p-aminophenol metal–organic framework (Cu(PAP)2) is first reported. Powder X-ray diffraction (PXRD), infrared spectra (FTIR), Raman spectra, transmission electron microscopy (TEM) and X-ray photoemission spectroscopy (XPS), in combination with a structure simulation, indicated that Cu(PAP)2 is a two-dimensional (2D) material with a staggered structure analogous to that of graphite. Based on its 2D graphite-like layer structure, Cu(PAP)2 was expected to exhibit preferable tribological behaviors as an additive in liquid lubricants, and the tribological properties of Cu(PAP)2 as a lubricating additive in hydrogenated polydecene (PAO6) or deionized water were investigated. Compared to PAO6 or deionized water, the results indicated that deionized water-based Cu(PAP)2 showed much better friction reduction and anti-wear behavior than PAO6-based Cu(PAP)2 did, which was due to Cu(PAP)2 penetrating the interface between friction pairs in deionized water, but not in PAO6, thus producing lower friction and wear resistance values.