Here, a novel copper p-aminophenol metal–organic framework (Cu(PAP)2) is first reported. Powder X-ray diffraction (PXRD), infrared spectra (FTIR), Raman spectra, transmission electron microscopy (TEM) and X-ray photoemission spectroscopy (XPS), in combination with a structure simulation, indicated that Cu(PAP)2 is a two-dimensional (2D) material with a staggered structure analogous to that of graphite. Based on its 2D graphite-like layer structure, Cu(PAP)2 was expected to exhibit preferable tribological behaviors as an additive in liquid lubricants, and the tribological properties of Cu(PAP)2 as a lubricating additive in hydrogenated polydecene (PAO6) or deionized water were investigated. Compared to PAO6 or deionized water, the results indicated that deionized water-based Cu(PAP)2 showed much better friction reduction and anti-wear behavior than PAO6-based Cu(PAP)2 did, which was due to Cu(PAP)2 penetrating the interface between friction pairs in deionized water, but not in PAO6, thus producing lower friction and wear resistance values.
In this study, we report a low-temperature approach involving a combination of a sol–gel hydrothermal method and spark plasma sintering (SPS) for the fabrication of cubic phase ZrW2−xMoxO8 (0.00 ≤ x ≤ 2.00) bulk ceramics. The cubic-ZrW2−xMoxO8 (0.00 ≤ x ≤ 1.50) bulk ceramics were successfully synthesized within a temperature range of 623–923 K in a very short amount of time (6–7 min), which is several hundred degrees lower than the typical solid-state approach. Meanwhile, scanning electron microscopy and density measurements revealed that the cubic-ZrW2−xMoxO8 (0.00 ≤ x ≤ 1.50) bulk ceramics were densified to more than 90%. X-ray diffraction (XRD) results revealed that the cubic phase ZrW2−xMoxO8 (0.00 ≤ x ≤ 1.5) bulk ceramics, as well as the sol–gel-hydrothermally synthesized ZrW2−xMoxO7(OH)2·2H2O precursors correspond to their respective pure single phases. The bulk ceramics demonstrated negative thermal expansion characteristics, and the coefficients of negative thermal expansion were shown to be tunable in cubic-ZrW2−xMoxO8 bulk ceramics with respect to x value and sintering temperature. The cubic-ZrW2−xMoxO8 solid solution can thus have potential applications in electronic devices such as heat sinks that require regulation of thermal expansion.