Rongjun Wang

Dr. Rongjun Wang

orcid

Research Focus & Metrics

Academic Career Length

8Years (2019-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
20 July 2022 in Journal of Electronic Materials
Verified
Journal Article
Closed access
PDF file
PZPengchong Zhang
Pengchong Zhang
JLJinguang Lai
Jinguang Lai
RWRongjun Wang
Rongjun Wang

18 March 2019 in Materials Research Express
Verified
Journal Article
Closed access
PDF file
RWRongjun Wang
Rongjun Wang
QZQiang Zhang
Qiang Zhang
PZPengchong Zhang
Pengchong Zhang
XLXin Liu
Xin Liu
SYShengnan Yuan
Shengnan Yuan
LMLiFeng Ma
LiFeng Ma
Currently, magnesium alloys are extensively used owing to their excellent comprehensive mechanical properties. Rolling is a primary method used to produce magnesium alloy plates. However, so far, only few reports have been investigated about the straightening of rolled magnesium alloy plates. In this study, multi-roller straightening of the magnesium alloy plate is theoretically analyzed and simulated using the finite element method. Multi-roller straightening process of the magnesium alloy plate was performed as follows: the original bending curvature that exhibited large numerical differences in different directions was gradually reduced through reasonable distribution of the plastic deformation rate of each straightening roller system. Finite element simulation and experimental results are obtained for room-temperature magnesium alloy plate straightening at four different plastic deformation rates. However, the straightening effect is minimal when the micro plastic deformation rate is used for straightening the magnesium alloy plate with an initial curvature, this is because the reverse bending rate required for straightening is not attained. Straightening effect can be achieved with low, moderate, or high plastic deformation rates, and the flatness achieved after straightening at a low plastic deformation rate is relatively better than that obtained using moderate and high deformation rates. Both perpendicular to and along the straightening direction, the residual stress after straightening is less than that observed before straightening. Furthermore, the residual stress after straightening at a low plastic deformation rate is the lowest and uniformly distributed.

1 January 2020 in Advances in Materials Science and Engineering
Verified
Journal Article
Open access
PDF file
XYXia Yang
Xia Yang
YMYingchao Ma
Yingchao Ma
DHDongsheng He
Dongsheng He
XDXiaozhong Du
Xiaozhong Du
RWRongjun Wang
Rongjun Wang
In order to have both the surface corrosion resistance of aluminum alloy and the high specific strength characteristics of titanium alloy, titanium alloy TC4, and aluminum alloy 6061 can be used to make aluminum‐titanium‐aluminum (Al‐Ti‐Al) three‐layer laminated plate by hot rolling. In this paper, the classical laminated plate theory was used to calculate the stiffness, specific stiffness, strength, and specific strength of the laminated plate. The results showed that when the coating rate of titanium alloy TC4 was 0.5, bending specific stiffness and bending specific strength were the minimum, but all other parameters increased with the increase of the coating rate of titanium alloy TC4. Therefore, in actual production, the coating rate of titanium alloy should be avoided being 0.5. Then, the rolling experiments of the Al‐Ti‐Al laminated plate were carried out with different temperatures, reduction rates, and thickness ratios. Finally, the tensile test and energy spectrum analysis of the laminated plate were carried out. The results showed that, with the increase of rolling temperature, the tensile strength, the extensibility, and the thickness of the diffusion layer increased; if the coating rate of titanium alloy TC4 was between 0.2 and 0.33, the mechanical properties, the bonding strength, and the thickness of the diffusion layer increased with the increase of the coating rate of titanium alloy TC4.