Understanding the relationship between germination rate and temperature is crucial in predicting crop establishment. Piecewise-linear (broken-stick) functions have been suggested to model this relationship. The aim of this paper was to assess how previously suggested triangular-shaped (TS) and plateau-shaped (PS) models performed for seven common Mediterranean crops: pea (Pisum sativum L.), lupine (Lupinus luteus L.), chickpea (Cicer arietinum L.), broad bean (Vicia faba L.), sunflower (Helianthus annuus L.), corn (Zea mays L.), and sorghum (Sorghum vulgare L.). Experiments were performed using a thermogradient plate, with temperatures monitored by Cu-CuNi thermocouples. Five temperature ranges, suitable to the thermal responses of each crop, were used. The TS and PS models were fitted to the resulting time to germination vs. mean temperature datasets. The choice of temperature ranges (sub- and supraoptimal in both the TS and the PS models, and an additional intermediate optimal range in the PS model) considered all possible partitions of the data points. The partition that provided the best fit was chosen. The germination rate-temperature relationship was well described by both models. The choice of model affected estimates of cardinal temperatures, thermal times, and maximum rates of germination. Differences were especially noticeable for the heavier-seed crops (broad bean, chickpea, and corn), encouraging the widespread use of the PS model to simulate these relationships. Although slightly more complex than the triangular model, the plateau-shaped model provided a range of optimal temperatures, which has practical advantages from the farmers’ point of view, enabling them to assess the impact of foreseeable weather fluctuations.
1 October 2010 in Revista Brasileira de Ciência do Solo
The removal of the litter layer in Portuguese pine forests would reduce fire hazard, but on the other hand this practice would influence the thermal regime of the soil, hence affecting soil biological activity, litter decomposition and nutrient dynamics. Temperature profiles of a sandy soil (Haplic Podzol) under a pine forest were measured with thermocouples at depths to 16 cm, with and without litter layer. The litter layer acted as a thermal insulator, reducing the amplitude of the periodic temperature variation in the mineral soil underneath and increasing damping depths, particularly at low soil water contents. At the mineral soil surface the reduction of amplitudes was about 2.5 ºC in the annual cycle and 5 to 6.7 ºC in the daily cycle, depending on the soil water content. When soil was both cold and wet, mean daily soil temperatures were higher (about 1 - 1.5 ºC) under the litter layer. Improved soil thermal conditions under the litter layer recommend its retention as a forest management practice to follow in general.
Pinus pinea is widely distributed in the Mediterranean basin. In Portugal, it is predominantly located in the southwestern coastal area. Yet, there are also forest areas of Pinus pinea in inland southern Portugal. Four plots were settled to study the effects of soil chemical characteristics, air temperature and precipitation on Pinus pinea growth. In these plots, stand structure, soil texture, soil organic matter, soil content on macronutrients and micronutrients, air temperature and precipitation were analysed. The results indicate that the greatest growth was achieved in the plots with good availability of nutrients and the highest precipitation, whereas the lowest growth was observed in the plots with the lowest precipitation. There seems to be a trend toward the main limiting factor to Pinus pinea growth being the availability of water.