We demonstrate a low-cost standalone portable spectrophotometer for fast and reliable measurement execution. The data acquired can be both displayed via a dedicated smartphone application or a computer interface, allowing users either to gather and view data on the move or set up a continuous experiment. All design and software files are open-source and are intended for the device to be easily replicable and further customizable to suit specific applications. The assembled device can measure absorption in the wavelength range from 450 nm to 750 nm with a resolution of 15 nm and is housed in a 90 × 85 × 58 mm casing. Validation of the device was carried out by assessing wavelength accuracy, dynamic range and the signal-to-noise ratio of the system, followed by testing in three different applications where limit of quantification, limit of detection and relative standard deviations were determined. The results indicated better performance than low-cost spectrophotometers, on average being comparable to moderate to high-cost spectrophotometers.

Zirconia is a relatively new material with many promising practical applications in medical imaging, biolabeling, sensors, and other fields. In this study we have investigated lanthanide and niobium doped zirconia by luminescence and XRD methods. It was proven that charge compensation in different zirconia phases determines the incorporation of intrinsic defects and activators. Thus, the structure of zirconia does not affect the Er luminescence directly; however, it strongly affects the defect distribution around lanthanide ions and the way in which activator ions are incorporated in the lattice. Our results demonstrate the correlation between the crystalline phase of zirconia and charge compensation, as well as the contribution of different nanocrystal grain sizes. In addition, our experimental results verify the theoretical studies of metastable (tetragonal, cubic) phase stabilization determined using only oxygen vacancies. Moreover, it was found that adding niobium drastically increases activator luminescence intensity, which makes Ln³⁺ doped zirconia even more attractive for various practical applications. Although this study was based on the luminescence of the Er ion, the phase stabilization, charge compensation, and luminescence properties described in our results are expected to be similar for other lanthanide elements. Our results suggest that the luminescence intensity of other oxide matrices where lanthanides incorporate in place of tetravalent cations could be increased by addition of Nb ions.

It is known that doping zinc sulfide (ZnS) nanoparticles with Mn or Cu ions significantly affects their luminescent properties. Herein, we investigated how dopant atoms are incorporated into the structure of ZnS using X-ray diffraction and multi-edge X-ray absorption spectroscopy. The observed broadening of the X-ray diffraction patterns indicates an average crystallite size of about 6 nm. By analyzing the Zn, Mn, and Cu K-edge extended X-ray absorption fine structure (EXAFS) spectra using the reverse Monte Carlo method, we were able to determine the relaxations of the local environments around the dopants. Our findings suggested that upon the substitution of Zn by Mn or Cu ions, there is a shortening of the Cu–S bonds by 0.08 Å, whereas the Mn–S bonds exhibited lengthening by 0.07 Å. These experimental results were further confirmed by first-principles density functional theory calculations, which explained the increase in the Mn–S bond lengths due to the high-spin state of Mn${}^{2+}$ ions.

This study compares HfO₂ ceramics synthesized using sol–gel and combustion methods, emphasizing the impact of the method of synthesis on the resulting properties of the material. The research findings illustrate morphological differences between sol–gel and combustion-derived HfO₂. While sol–gel samples displayed irregular nanoparticles with pronounced boundaries, combustion samples revealed more homogeneous structures with particles tending towards coalescence. It was discerned that Eu³⁺ doping induced oxygen vacancies, stabilizing the tetragonal phase, while subsequent doping with Nb⁵⁺ significantly reduced these vacancies, which was also observed in photoluminescence analysis. Furthermore, combustion synthesis left fewer organic residues, with urea presence during synthesis contributing to residual organic components in the material. XPS analysis was used to evaluate the presence of oxygen-deficient hafnia sub-oxide in the samples. The study underscores the important role of tailored synthesis methods in optimizing the properties and applications of HfO₂.