The capability of 3D printing technologies for direct production of complex 3D structures in a single step has recently attracted an ever increasing interest within the field of microfluidics. Recently, ultrafast lasers have also allowed developing new methods for production of internal microfluidic channels within the bulk of glass and polymer materials by direct internal 3D laser writing. This review critically summarizes the latest advances in the production of microfluidic 3D structures by using 3D printing technologies and direct internal 3D laser writing fabrication methods. Current applications of these rapid prototyped microfluidic platforms in biology will be also discussed. These include imaging of cells and living organisms, electrochemical detection of viruses and neurotransmitters, and studies in drug transport and induced-release of adenosine triphosphate from erythrocytes.

We demonstrate a low-cost standalone portable spectrophotometer for fast and reliable measurement execution. The data acquired can be both displayed via a dedicated smartphone application or a computer interface, allowing users either to gather and view data on the move or set up a continuous experiment. All design and software files are open-source and are intended for the device to be easily replicable and further customizable to suit specific applications. The assembled device can measure absorption in the wavelength range from 450 nm to 750 nm with a resolution of 15 nm and is housed in a 90 × 85 × 58 mm casing. Validation of the device was carried out by assessing wavelength accuracy, dynamic range and the signal-to-noise ratio of the system, followed by testing in three different applications where limit of quantification, limit of detection and relative standard deviations were determined. The results indicated better performance than low-cost spectrophotometers, on average being comparable to moderate to high-cost spectrophotometers.

A new approach for the integration of dual contactless conductivity and amperometric detection with an electrophoresis microchip system is presented. The PDMS layer with the embedded channels was reversibly sealed to a thin glass substrate (400 μm), on top of which a palladium electrode had been previously fabricated enabling end-channel amperometric detection. The thin glass substrate served also as a physical wall between the separation channel and the sensing copper electrodes for contactless conductivity detection. The latter were not integrated in the microfluidic device, but fabricated on an independent plastic substrate allowing a simpler and more cost-effective fabrication of the chip. PDMS/glass chips with merely contactless conductivity detection were first characterized in terms of sensitivity, efficiency and reproducibility. The separation efficiency of this system was found to be similar or slightly superior to other systems reported in the literature. The simultaneous determination of ionic and electroactive species was illustrated by the separation of peroxynitrite degradation products, i.e. NO₃ ⁻ (non-electroactive) and NO₂ ⁻ (electroactive), using hybrid PDMS/glass chips with dual contactless conductivity and amperometric detection. While both ions were detected by contactless conductivity detection with good efficiency, NO₂ ⁻ was also simultaneously detected amperometrically with a significant enhancement in sensitivity compared to contactless conductivity detection.